Search results

■TiO2 decorated multiwalled carbon nanotubes;●Fe2O3 decorated multiwalled carbon nanotubues. 4.Conclusion Electron-beam treatment combined with decorated multiwalled carbon nanotubes is suitable for the reduction of dyeing wastewateand.
Decolorization and COD reduction of dyeing wastewater from a cotton textile mill using thermolysis and coagulation.
New data on electron-beam purification of wastewater.

Ultrasonic Inspection Data for Typical 2 Sheet SPF/DB Component Fig. 5.
Not only is there a large weight reduction in switching from inconel to titanium but also a large cost reduction due to significantly shorter flow time for this application.

Previously it was showed that copper addition to steel and cast iron leads to its coefficient of friction reduction.
Increase of copper content up to 6.57 wt. % led to the reduction of the thickness of the chilled layer.
The obtained results correlated with the data presented in [5, 6].

This practice does not meet the requirement of energy conservation, emission reduction, low carbon and environmental protection.
This paper chose Parasolid(.x_t) interface for data transfer between Adams and parametric entity models.
The reduction of the amplitude at the rear end of the vibrating screen makes for kernel separation.

It is observed in a high-cycle fatigue range as an increase in fatigue strength and fatigue life with a reduction in the cross-sectional area of tested specimens.
A data scatter is described as a coefficient of determination (Fig. 7).
The reduction of tested specimen below a recommended size will reveal local material properties and yield an increased scatter of the results.

These results are in good agreement with the data obtained from IR spectra (Fig.1b).
The proposed reduction treatment under high vacuum conditions at 1250-1400oC is a simple way to reduce TiO2 to non-stoichiometric titanium dioxide TiO2-x.
Sato, Thermoelectric properties of non-stoichiometric titanium dioxide TiO2-x fabricated by reduction treatment using carbon powder, Mater.

Therefore, it can be concluded that reduction of W0 led to simultaneous reduction of the average diameter and the amount of synthesized copper nanoparticles.
The obtained UV data shows the effect of aging time on the preparation of CuO nanoparticles in which complete conversion of CuCl2 to Cu occurs at 24 h.

Aging was the relaxation process of coating materials that occured in its glassy state resulting from its nonequilibrium state accompanying by a reduction in the level of free volume, enthalpy, entropy and glass transition temperature of the coatings[3].
If the temperature exceeded the dissociation energy of polymer chemical bond, the molecular chain would degradate resulting in discoloration, embrittlement and strength reduction.
These techniques gave data that could be correlated with performance [28], but (with the possible exception of contact angle) they did not provide atomicscale details of degradation.

One advantage of this type of clinker/cement is the decrease of the energy consumption (reduction of the clinkering temperature) and CO2 emissions.
This reduction has obvious procedural and economic benefits and results from the presence, in some of the wastes, of mineralizing impurities (e.g. alkali).
Duda, Cement Data Book, Volume 1: Process Engineering in the Cement Industry, third ed., Bauverlag Gmb H, Wiesbaden und Berlin (1985)

Earlier works involved simplified models, but with reduction of computation cost, many process complexities are being incorporated to make more realistic models.
To determine the parameters of the law of Leblond for the phase transformations, the data must be extracted from the continuous cooling transformation (CCT) diagram.
The distortion with cooling, show reduction in 0.48 mm i.e. 4.4% for without phase transformation and 2.53 mm i.e. 22.1% for with phase transformation.