Search results

These data are of great importance for practical applications.
A reduction of E1 and E2, without loss in strength, was observed after HT 500-550ºC, Fig. 2 (b).
Further reduction of the modules in the state after HT 500-550ºC can be explained by RMT when the B2 phase (with higher mechanical properties [4]) appear, coexisting with R and B19' phases.

Flowchart for the processing of the pregnant solution The coefficient of determination (R2) in both cases was more than 0.98, which indicates a good fitting of experimental data with the obtained equations.
Zhou, High-rate precipitation of iron as jarosite by using a combination process of electrolytic reduction and biological oxidation, Hydrometallurgy. 143 (2014) 23-27 [10] J.E.
The reduction of Fe(III) to Fe(II) with cellulose, Can.

Data was analyzed by analysis of variance (ANOVA) using SPSS (SPSS Inc., Chicago, IL, USA).
The development of a heterogeneous film structure featuring discontinuities along the polymer matrix caused the reduction of the tensile strength of the poly(lactic acid) films containing essential oil [10].
Essential oil can act as a plasticizer causing a reduction in the intermolecular forces along the polymer chains, which is stronger than the interaction between polar essential oil molecule and polar polymer molecule [11].

Apart from this, elemental composition of particulate plays an important role in the physical and chemical characteristics of particulate matters (PM) and provides interesting data, not only for the evaluation of its impact on human health, ecology and environment but also for the identification of specific emission sources[5].
[8] WHO, Ambient Air Pollution: A global assessment of exposure and burden of disease, World Health Organization, Geneva, (2016) (http://www.who.int/phe/publications/air-pollution-global-assessment/en/) [9] N.Tserenbat, Current situation of air pollution and solutions for its reduction.
National Forum on Reduction of Air Pollution, Abstract book, 2017

Structural analysis is performed by X Rays Diffraction and the data are treated using the RIETVELD method.
The applied current causes the reduction of H2O2 which results in a strong decrease of dihydrogen emission from the cathode. [10].
The X-ray data are collected for 2θ ranging from 10° to 60° using a monochromatic CuKα radiation with the step of 0.06° every 60s.

The data presented are useful for the analysis of the structural modifications that occur and develop during the operation of a screw compressor, with the possibility to predict a failure.
The screw compressors with oil injected screw have many advantages, such as: the rotor is directly coupled to the driving motor, which means costs reduction, oil injection ensures a tight seal between rotors and housing, namely protection against corrosion, diminution of noises, robustness and high reliability, exhaust temperature control, thus avoiding the problems caused by the dew point, tolerance to liquid particles, low vibrations.
To maintain the compressor in running condition, the following operations must be monitored, performed and entered in the register: checking of tightness, testing of oil acidity,recording of pressure, temperatures, operation electric power and voltage, check the operation of the equipment/ comparison of the operating conditions against the original data of commissioning and the Instructions Book, checking the oil condition by means of the microscope at 1000 hours, 4000 hours, 5000 hours, 7000 hours, with the associated decisions of maintenance [2,12].

It allows the direct use of experimental measurement as input data.
A 1400x1000 pixels map from EBSD was used as input data.
Clearly the conditions H=10° and n=4 produce the best agreement with experimental data.
CA: As an input data an EBSD map was used corresponding to a population of 9200 grains, having a 3µm average size.
The main difference which will have the effect on grain growth behavior lies in the form of the input data.

The key idea behind their scheme is that the AP allocates time slots to its clients, during which the clients may send data to or receive data from the AP.
In this article, we suppose that the stations which operate in non-HT transmit or receive the data frames in SISO mode and in non-HT PLCP Protocol Data Unit (PPDU) format.
,NSS NSD Number of data subcarriers NSP Number of pilot subcarriers NCBPS Number of coded bits per OFDM symbol NDBPS Number of data bits per OFDM symbol NES Number of BCC encoders for the DATA field NTBPS Total bits per subcarrier Energy efficiencies of a legacy data block transmitted in non-HT and HT.
Fig. 1 also shows that even if the data rate is low to 24 Mbps in MCS 24, the MAC efficiency of the stations is almost the same with those of stations in non-HT mode with 36 Mbps data rate.
Energy efficiencies of a large data block transmitted in non-HT and HT.

This research provides foundational data for chitin and chitosan derived from crab shell species in Ireland.
Enthalpy (ΔH) and transition temperatures (onset (To), peak (Tp) and completion (Tc)) were analysed based on the curve produced using the Pyris Series Data Analysis software.
The spectral data obtained in this study are comparable to findings from various sources that utilised similar methods for chitin extraction [18, 62-65], confirming the diagnostic nature of these bands for crab shell materials.
The mineral CaCO3, present at approximately 1412 cm-1 and 869 cm-1 in CSW, aligns with spectral data for the same mineral reported in other literature [66].
Table 4 Pore measurement data by ImageJ.

We analyze the global natural gas consumption and price points using the data from the BP.
In order to eliminate the impact per unit, the regression model uses the data in the log.
As a result, the market data can meet the requirements of the model.
Unit Root Estimation Data should be inspection for stationarity before equation estimation, only Stationary sequence can be used.
In order to eliminate the impact per unit, the regression model make return more believable on the data of log.