Search results

.%, (ii) the rate of volatilisation of solvent influences the differential shrinkage between layers; in the worst case scenario the base layer has fully dried so that its shrinkage is complete when the next layer begins to dry, (iii) the span between filaments determines the number of welds per unit area and hence overall laminate strength, (iv) as the span decreases and the lattice becomes more densely packed, the vapour transport within the structure decreases and drying rate slows down, in turn reducing drying deformation.
At high porosity, the number of welds per unit area is low and delamination is facilitated.
Acknowledgements The authors are grateful to the Engineering and Physical Sciences Research Council (EPSRC) for supporting this work under grant number GR/S57068.
Safari, An Overview of Rapidly Prototyped Piezoelectric Actuators and Grain-Oriented Ceramics, J. electro. ceram., Vol. 8(2002), PP. 129-137

Measurements were taken at a number of positions in the plane of the crack, at the mid height and mid thickness of the specimens.
To ensure that sufficiently large number of grains is included in the measurements a gauge volume of 2 × 2 × 2 mm3 on specimens 16 and 23 and 3 × 3 × 3 mm3 on specimen 26 was used for ND measurements.
Different gauge volumes were used to optimise the number of measurements can be made during the available beam time.

The number of studies on nanotechnology related to the number of studies on nanotechnology related to the petroleum industry has been growing rapidly in the past few years.
In the petroleum industry, The utilized cement in the oil wells is classified as class G cement, which is different from Portland cement by a low amount of “celite” (C3A) and has larger grains than usual Portland cements [10].
Cement class mixtures were prepared using two different groups of Nano materials, which are (Nano cement dust ,Zno Nano rods) in four concentrations (0.25%, 0.5%, 0.75%, and 1%) per weight .In order to achieve these steps, number of samples were designed for oil well cement class “G” that must apply 792 gm weight of cement and 349 gm water, according to the American Petroleum Institute (API, 1997) in (9) classes, from A to J.

However, many natural phenomena are better described using a dimension between two whole numbers.
When a system builds internal models or internal representations of itself as aid to self-organizing autonomous behavior, the system falls under pressure to develop "realistically" fine-grained self-models because the capacity of the system in question for self-organizing behavior will obviously depend on the extent to which the system can accurately represent the fine details or minutiae of its own structure in its "inner" self-representations.
Such a changing organization structure can always keep the same staff number throughout the project, but can complete all the work. facing a flux state, each organization member is required self-organization and self-control, to ensure the entire organization good operation[5].
Meanwhile, a number of different tasks can be broken into more little projects at the same time, task execution efficiency is improved.

Biological disasters- More than 1,400 types of pests and rodents cause losses of nearly 50 million tons of grain and over 1 million tons of cotton.
The expanded role also means an integration of a number of disciplines and a number of expertises drawn from different areas.
JOURNAL OF SPATIAL INFORMATION SCIENCE Number 1 pp. 3–20 doi:10.5311/JOSIS.2010.1.2.

In addition, many studies found that oil hydrocarbons entering the soil scattered the soil grain and reduced water permeability [14, 15].
The results showed that there was no significant difference on the number of the microorganism between the polluted and unpolluted soil, but in oil-contaminated soil, the number of hydrocarbon degrading bacteria significantly increased.
Zhao et al. analyzed the total number of microbe in Panjin reed wetland, and found that bacteria were the advantage community among the wetland soil microbes, followed by actinomycete and fungi [27].

A large number of additives research has been done to improve the anode performance and reduce the anode consumpution, which is based on different effects of some elements at the quality and consumption of carbon anode.
There is not abscission of large grained aggregate coke in the subsequent forced pull-off.
Moisture, CO2, CO, light oil and a large number of micromolecule fugitive constituent are released from the pitch.
The number of carbocycle contained in each carbon lamellasome increases by 14.1%, from 158 to 178.

The reference standards are: 3 leaves and 1 heart, height 12 ~ 20cm, stem width not less than 2mm, root number 12 ~ 15 / seedlings.
Differences of the traditional nursery and the seedling transplanter Transplanting seedlings is to machine transplanting plantlets, seedling index is: Seedling age at 15-20 days, leaf age 3.5-3.8 leaves, height of 12-17 cm (6 inch), white roots number more than 10, seedling per square centimeter of 2-3 strain, neat uniform, green but disease-free, seedling block packing, filed not scattered.
Actively carry out the rice production machinery test selection, and mainly support the promotion of a number of advanced and applicable, safe, energy saving and environmental protection type of paddy rice production mechanization.
Support agricultural cooperatives, large agricultural machinery, large grain and technology demonstration households, the establishment of seedlings and planting machinery company.

This extraordinary fine-grained powder is polluting the cartridges, and printers also.
Rate of inventory turnover, (quotient of the annual average inventory multiplied by 365 days – number of days in a year – to net revenues from sales of products, goods and materials), which is a measure of the capital efficiency that is employed in company inventories.
Term debt repayment, (the ratio of the average annual state of total liabilities from deliveries and services, multiplied by 365 days – number of days in a year – for net proceeds of sales of products, goods and materials), which informs about the average number of days elapsed since the date of purchase of materials, goods on credit until its repayment.

The increase in the crystallite size is due to the incorporation of Cu2+and is attributed to the creation of tin or Oxygen vacancies and also leads to the assembly of bigger grains of Cu-doped SnO2 compared to pure SnO2 respectively [15,16].
Number of unit cell in the crystal is calculated using the relation n= πD3/6V (4) where D is the crystallite size and V is the volume of the unit cell[18].
The number of unit cell in the crystallite increases as the crystallite size increases and is given in table 1.
Samples Lattice Parameters Cell Volume V=a2 c Crystallite size nm Number of unit cell in the crystal Band gap eV aÅ cÅ Pure SnO2 4.70594 3.16065 69.9954 3.871 433 3.99 0.2% Cu 4.68142 3.21577 70.4757 4.160 534 3.96 0.6% Cu 4.69746 3.21388 70.9178 4.587 712 3.94 1.0% Cu 4.83678 3.1663 74.0698 4.835 798 3.93 Figure 1.