Search results

Fig.3 Effects of the subcascade formation, where the data points are the mean values over all cascades at each number and the bars indicate the standard error. 1 2 3 4 5 0 20 40 60 80 Number of the disordered areas Number of frenkel pairs 1 2 3 4 5 0 5 10 15 20 25 Number of the disordered areas Maximum size of clusters Interstitial cluster Vacancy clusterThe detail of defect clustering.
During the reduction in the disordered area, the SIA again moves in the basal plane.

Due to the lack of detailed chemical data regarding the deposition of ZnO film from Zn (C2H5)2, one overall surface chemical reaction on the substrate was assumed: O5H4COZnO7O)HC(Zn 22 2252 ++=+ Results and discussion Temperature is an important factor during the film growth process.
It is possible due to the increase of flow rate which cause the dramatically reduction of the time for initial detection and the time for reaching steady state [4].

The field effect mobility was calculated from the data of transfer characteristics at a drain voltage of 0.1 V in lateral MOSFETs with the channels parallel to the [110] and [-110]-directions.
It is expected that the leakage current at the high temperature decreases more by the reduction of the traps in the depletion layer.

Reference [5] synthesized the existing methods in the field of model reduction.
Fig. 5 Simulation diagram for the parallel MRAS Fig. 6 Mathematical model subsystem Fig. 7 Adjustable system subsystem Fig. 8 Adaptation mechanism subsystem Table 1 Simulation data Parameter Jm Mt cb fb l ci K ft ct Unit [Kgm2] [kg] [Nm/(rad/s)] [Nm] [m] [N/(m/s)] [N/m] [N] [N/(m/s)] Value 0.00302 80 0.0031 0.44 0.02 6000 1.3*108 70 100 Choose α1=α2=1, β1=β2=1*10-8,d1=0.5, When the input is band-limited white noise, whose noise power is one , the simulation results shown in Fig. 9.

Two online algorithms are presented for variable speed limit controls at highway work zones that can take full advantage of all dynamic functions and concurrently achieve the objectives of queue reduction or throughput maximization [2].
The main functions of the fuzzification interface are to measure the values of input variables, to perform a scale mapping that transfers the range of values of input variables into corresponding universes of discourse, and to perform the fuzzification that converts input data into suitable linguistic values.

The maximum data hold time is 10ms.
Noise reduction and low power consumption are subjects for further research.

In addition to this, it is known that the reduction of area percentage of patented pearlite under tensile deformation is inversely proportional to the square root of pearlite colony [2].
Stress-strain relationship is determined by experimental data [6] which is defined by the swift equation [7] given as follows: 　 (2) whereanddenote as stress and plastic strain, respectively, whereas a, b and n are constants.

World aluminum industry association reported that the weight of the car has a linear relation to energy consumption,1% reducing of vehicle weight can save fuel by 0.6%~0.8%[1].Advanced high-strength steel (AHSS) have been used in the automotive industry as a solution for the weight reduction, safety performance improvement and cost saving.
In order to investigate the influence of factors on the welding joint quality, extreme difference analysis was made for the data in table 3, and get the average tensile shear load value under different levels of the three factors A, B, C.

The data is exchanged between Hydism and iSIGHT.
In optimization result of 4 Schemes, the optimization effects of spray cone are not ideal, and the maximum reduction range of Saunter mean diameter is 18.2%, the minimum is 5.6%, so, the optimization effect of Saunter mean diameter is ideal.

Research on Vibration Characteristics and Seismic Response of Shell of LNG Tank Jing Ji1,a, Tao Yang2, b, Wenfu Zhang1,c , Liang Chang1,d, and Haiyan Sui1,e 1 Provincial key Lab of Disaster Prevention and Reduction Engineering and Protective Engineering, Northeast Petroleum University, Daqing, Heilongjiang,163318, China 2 Shijiazhuang Design and Research Institute of Coal Industry, 050056, China ajijing1977@163.com, bdqpiyangtao@126.com, czwfdqpi@126.com, ddqpi15@163.com, esuihaiyan2010@126.com Keywords: Shell of LNG Tank; Vibration Characteristic; Seismic Response; Time-History Analysis Abstract.
According to in the data provided the document [1], setting parameters of finite element model of LNG storage tanks in this article, their basic parameters shown in Table 1.