Search results

Corrosive environment leads to reduction of durability.
As can be seen from the presented data, increase of loading cycles number decreases the electrode potential of the metal and, consequently, its thermodynamic stability.

Reduction in size is possibly due to inhibition of Ostwald ripening, and to favor the nucleation mechanism [6].
Rietveld analysis uses diffraction data to perform a fit by a mathematical and phenomenological model.

Model of calculation priority risk number Conclusion Suggested development of the method allows developing measures aimed at reduction of independent nonconformity probability and negative implications of nonconformities as well as impacting the frequency of dependent nonconformities.
Life cost based FMEA incorporating data uncertainty.

Many methods can be used to prepare the CuOx materials, such as chemical reduction, hydrothermal synthesis, thermal oxidation and other synthetic techniques [5-7].
XRD data (Fig.1c) show peaks of Cu2O and broad peaks of CuO phase.

The deformation is collected by the data collection system automatically.
Through time reduction coefficients (e (e = t/f0)) of the creep compliance of building silicone sealant under differences stress lever meet to the following equivalent relation [4]: (2) Where is the creep compliance master curve under reference stress s0.

Robotic solenoid housing placement and assembling systems have enormous potential for realizing high productivity, system flexibility, and cost reductions in solenoid manufacturing.
This ability depends on the ability of its vision system to provide accurate data.

Currently, the problem may be tackled in four ways: i) Direct chemical methods, ii) Electrochemical treatments, iii) Ion exchange and biosorption methods, iv) Use of growing microbial cells which enables metal precipitation, reduction and/or accumulation via metabolic processes.
After the analysis of the feasibility data and the modelling of the bioprocess at laboratory scale, the above mentioned techniques will be scaled-up and optimized.

The record is matched with the JCPDS data bank to track the evolution of phases during mechanical alloying/milling.
The patterns showed continuous broadening and reduction in the intensity of the peaks, thus evidencing refinement of the W crystallite size by ball milling.

Electroless plating refers to the deposition of metal on a substrate by oxidation-reduction reaction without external electric current [5].
Materials TSSA (m2/g) MSSA (m2/g) TPV (cm3/g) MPV (cm3/g) APD (Å) ACF 1,598 1583 0.91 0.86 17.7 ACF/Cu 865 860 0.59 0.55 16.6 ACF/Ag 1383 1347 0.58 0.55 17.0 *TSSA: Total specific surface area *MSSA: Micropore specific surface area *TPV: Total pore volume *MPV: Micropore volume *APD: Average pore diameter Table 3 shows summarized properties related to the adsorptive characteristics of ACF filters determined from the raw data of nitrogen adsorption isotherms according to BET equation and BJH method.

During the last years a reduction of the off-cut has been reconsidered mainly to reduce the crystal waste when slicing wafers with large diameter and due to the improvement of the crystal quality, polishing of the wafers and growth process.
Higher growth rates were reported by using trichlorosilane as silicon precursor at a high growth rate, but no surface morphology data was available [3].