Search results

Follows from the foregoing, PAM will be under constant pressure shortened if it leads to reduction in weight of the load.
Selected data recordings with CompactRIO Measurement conditions Measurement conditions are: pressure in compressor of 7,5 bar, pressure sensors power supply equal to 23V, 24V control valves power supply, pressure in artificial muscles equal to 2 bar, pressure tolerance of 0,05 bar, position tolerance of ± 1 °, operation without PWM modulation - 0% or 100%, operation with PWM modulation - 0 % to 100% with a frequency fPWM = 50 Hz, operation with no load - arm is a load of 400 N at the position angle 90 °, operation with a load - arm is a burden of 1310 N at the position angle 90 ° [15-18].

The data in Table 1 represent the stiffness reduction coefficient (SCR) of the material.

Boundary mis-orientation data, from the EBSD-OIM analysis typically appear as in Figure 6.[16] Fig. 6 Distribution of boundary misorientation obtained by EBSD.[16] The peak near the lower angles is probably caused by lath boundaries or subgrain boundaries inside the laths or other ferrite sub-units.
The improvement in properties was attributed to the reduction of softening from the Bs temperature to room temperature during the very slow cooling found in the coiling of large coils [25].

"Impact of COVID-19 induced lockdown on environmental quality in four indian megacities using landsat 8 OLI and TIRS-derived data and mamdani fuzzy logic modelling approach."
"Rethinking and optimising plastic waste management under COVID-19 pandemic: policy solutions based on redesign and reduction of single-use plastics and personal protective equipment."

The data taken were in the form of changes in resistance of carbon nanotubes versus time when the gas was injected or removed at ambient conditions.
Therefore, exposure of CNTs surface by CH4 results in the reduction of electron current and conductivity in the CNTs and more increment of electrical resistance than CO2 resulting in the higher sensitivity has been observed when CH4 was employed as tested gas.

The data taken were in the form of variations in CNTs electrical resistance versus time when the gas was injected or removed.
Therefore, exposure of CNTs surface by CH4 results in the reduction of electron current and conductivity in the CNTs and more increment of electrical resistance than CO2 resulting in the higher sensitivity has been observed when CH4 was employed as tested gas.

The cyclic loading process was controlled by displacement, using mixed loading schemes, that is, constant amplitude loading scheme together with variable amplitude loading scheme. (1) Constant amplitude loading scheme : applying load by constant displacement, to study the rules of strength reduction and stiffness degradation of walls; (2) Variable amplitude loading scheme : after each cycle, increasing cyclic displacement, to study the rules of shear strength and energy dissipation of walls by variable amplitude loading.
Conclusions (1) In order to provide test basis for the determination of economical and effective rowlock-wall constructional measures, the rowlock wall anti-seismic performance and failure mechanism were studied by the test results of the postiton of initial crack, distribution of crack, cracking load, ultimate load data obtained through the pseudo-static test of rowlock wall with different constructional measures.

The droplets have bigger inertia than air, which makes the reduction of droplet velocity smaller than that of air.
(a) Distributing diagram of velocity (b) Distributing diagram of pressure Fig. 5 Velocity and pressure distribution of inner cutting zone Six different air flow rates were applied and data of eighteen points along the arrow of Fig. 1 was recorded, as shown in Fig. 5.

Data analysis.
Ghiasi et.al. [19] also assumed that proteins involved in water absorption and transition which reduces the proportion of water/starch resulted in a gelatinization rate reduction.

One-way analysis of variance (ANOVA) was performed on the data of all tables and figure, and significant differences among the means were determined by multiple range tests.
Berkovitz, The reduction of fissure caries in Wistar rats by a soluble salt of nonanoinic acid, Arch.