Search results

Velocity of particles jet flow in ADM was measured by time-of–flight method, in which some part of particles flow was mechanically cut from the total flow and deposited onto moving substrate, the deflection of deposited pattern from the center axis, geometrical dimensions and moving speed of substrate provide a data of particles flow velocity [7]. � The values particles flows velocity was estimated as varied from 150 up to 500 m/s.
Reduction of crystallites size was observed after deposition for ceramic materials.

Fig. 4: FEM model, prediction of final sheet thickness, evaluation of localization and wrinkling Table 3: Most important data used for calculation of the costs of the part SPIF deep drawing Initial size of the blank 148 x 148 mm 200x200 / corner cut-offs of 25 mm Material costs 0.7 EUR / kg 0.7 EUR / kg Price of waste material No waste material 0.1 EUR/kg* Productivity (manual handling is assumed) 0.125 parts/minute 7 parts /minute Hourly rate (estimated by industry) 33.3 EUR / hour (milling machine) 25 EUR / hour (mechanical press) Costs of dedicated fixture parts 41 EUR Cost of dedicated tool 3000 EUR Cost of auxiliary operations 0,01 EUR / part 0,01 EUR / part Overhead expenses 20% 20% * the parts of the material which are cut from the corners of the blank can be sold as waste material 65 25 Punch Blank holder Die Blank Wrinkling 0 20 40 60 80 100 120 140 160 1 10 100 1000 10000 Production quantity Costs [€
All mentioned reasons force the reduction of the applied lubricants.

The research data on fiscal incentives in various regions by author is strong evidence for it.
Energy price issue Price is an important lever to promote energy-saving emission reduction.

Then we assume that the corrupted image satisfies (1) where thematrix (named mask, which contain the location of the non-missing pixels and missing pixels) denotes a linear operator which corrupts the image data.
The proposed method outperforms other filters in the noise reduction and the image details preservation.

l Analysis the experimental data. 2 The test step of liquid carrying capacity l When the foaming and stability ability test is over, keep the device calm until the foam in the simulate well is disappear, write down the simulated well fluid volume.
Water production in many wells, water rate is 5 ~ 67 m3/d, has caused the reduction of gas production, formation pressure also dropped to 23~32 MPa.

From technical and economical points of view, predicting the tool breakage allows a drastic cost reduction.
Torsor parameters: - Forces, - Torques, - Central axis Behaviour model Geometrical parameters: - Rake angle, - Lead angle - Cutting edge inclination Figure 3 Principle of behavior model Usually studies are based on models, which implement hypothesis on behavior laws, frontier conditions and geometrical data.

(b) Single nanoelectrodes; (c) Multiple nanoelectrodes; (d) Gap design for size expansion; (e) Bridge design for size reduction.
The data and results obtained are based on the optical characterization by using high power microscopy as in fig.6.

The numerical results obtained with the FE model were validated with experimental data. 1.
Reduction of the computational cost of the model without compromising a mesh size is a big challenge.

This can be achieved by increasing the nonsprung mass movement in exchange for the reduction of sprung mass vibration.
Through the analysis of time-domain simulation response curves and data, the semi-active suspension response to vertical vibration intensity can be reduced by about 10% relatively to passive suspension.

To verify and collect the data regarding the mobility parameters or the capability to clad in any direction, measurements were taken using the CAD model in Fig. 5.
This modification offered significant compression stress reduction, from 1.547 MPa to 0.413 MPa proving that the weight distribution got more even.