Search results

As the reduction approached 50% (~0.7 true strain), the flow stress approached to the steady state.
The data are analyzed with the help of available approaches and the following conclusions are drawn from this investigation: (1).

Introduction Multi-material systems are becoming attractive for complex lightweight constructions with respect to functionality, cost and weight reduction.
The data obtained were calculated based on the ZAF method. 3.

Irradiation of the samples with 1 MeV Kr ions shows good correlation with the data obtained by short-lived actinide doping.
Reduction of Tc enhances the radiation resistance of the matrices as a result of accelerating the recovery of structural damages.

All images were taken from the same sample.A further reduction of the twist component resulted in increasing dislocation spacings.
Assuming experimentally verified data (sizes of precipitates of about 5×5 nm², a thickness of about 10 nm, and a density of 1000 µm -2) the volume of the precipitates is about 10 -4 to 10-5 times less than that of a native oxide layer.

The main method to study aluminum alloy quenching sensitivity is drawing TTT curves , TTP curves and CCT curves of alloy through a large amount of experimental data, which can determine the quenching sensitivity temperature interval, critical cooling rate so that guide the actual setting of process parameter[5-7].
This is because the quenching media can contact the alloy more fully under water bath, which is good for the reduction of the alloy temperature.

The effect of oxidation of the samples on the creep data is meager.
The precipitation of fine Ti-silicides and the reduction in α/β colony sizes are primarily responsible for the obtained good mechanical behavior.

Data were collected from 2 theta from 10° to 80° in steps of 0.02 º/s.
When HPW was supported on the activated carbon, moderate reduction of its surface area and micropore volume was observed as shown in Table 1.

Data were processed with the Microsoft Excel software and Origin8.0.
Actually, the Cu and Pb concentration in the shoots of R. acetosa was reduced from the maximum at the second stage to 4.00 mg/kg and 2.56 mg/kg at the fourth stage, representing a reduction of 69.9% and 73.6%, respectively.

The data of yield and nitrogen uptake of maize in 6 years experiment (Fig.1 right) can be obtained from Gao et al. (2009) and Cai et al. (2012) in our project team.
The five treatments followed the local farmer traditional planting methods, planting density, sowing, and the harvest data, as well as fertilizer application period.
In China, Urea as a traditional nitrogen fertilizer was used widely, at the same time controlled release fertilizers as new style fertilizer were accepted by farmers, whose advantage of yield stability, N rate reduction and single basal application were evident in recent years.
According to the analysis of continuous 6 years data in high fertility soil, there was remarkable difference on nitrate accumulation between single basal fertilization and top-dressing fertilization (Fig.5), nitrate accumulation of single fertilization was less due to lower N fertilizer rate.
Available at http://data.stats.gov.cn/workspace/index;jsessionid=30B68ACED56F979E10E8ADD8131C9AE9?

Small, medium-sized and large scenarios with different storage and transportation costs were generated using parameters based on data from the literature.
Based on the data from the literature, a set of test problems with deterministic demand and a finite horizon was generated.
Because of the volume of data, the analysis of the results was restricted to six cost configurations.
Also worthy of note is the reduction for cost configurations MtHi and HtHi.
In general, when the mean data were divided into six different cost configurations the OU policy produced better results than the ML or EOQ policies.