Search results

Then, the columns are the only elements that can experience damage; the interaction and moment-curvature diagrams of them are the data needed to develop the Ruaumoko models.
Then, using in design process a double reinforcing steel percentage could produce important reductions in the elements and the structure mean damage.

For further quantitative analysis of the relationship between buildings damage and surface rupture, in accordance with the data of actual buildings damage and surface deformation measurement, the differential GPS survey about terrain and field survey about buildings damage were done in Shaba, Beichuan, its line profile and picture are shown in Fig.6.
[14] FANG Hai, LI Sheng-yu, et al. 2005.Research on earthquake-reduction design method of continuous girder bridges in a high-intensity earthquake area[J].

Idler Shaft: The idler shaft is one of the components of compound pulley system that effects speed reduction during the operation of the machine.
The data obtained from the tests shows that the machine performed effectively with regards to grating process while the extraction process still has plenty of scope for improvement.

Cu TaN TaN TiN Al2O3 Oxide Oxide Nitride Comparison of ALD Batch and Single Wafer Tools Table 3 provides a data sheet of comparison for the two tools.
There is a corresponding reduction in CoO from 14.6 €/wafer (200 mm) to 4.6 €/wafer mainly due to the increased throughput.

The <110> axially oriented grains tend to elongate by plane strain so that after large wire drawing reduction they become long ribbons that need to bend and interfold about the wire axis (grain curling in transverse sections) in order to maintain continuity of the polycrystalline aggregate.
Representative volume, boundary conditions and other data of the simulations The results to be presented correspond to quasi 2D simulations.

For instance, the reduction in size of the associated structural units corresponds to smaller resistance against flow, which results in lower viscosities.
However, the levels of viscosity are different, even though the shape of the data is similar, because not enough time was allowed in our previous measurements to reach the true steady state.

Therefore, reduction of the cooling cost is very effective for improving profitability.
The last year of data, which are the values in parentheses, show better results because of fewer problems.

Table 6: Descriptive statistical data of the impact strength test.
The remarkable reduction in the flexural strength found in these groups may be due to weak adhesion between coated fibers, and the resin is behind the decrement of the flexural strength.

For example, the divided flow method is a principal to reduce friction or hydrostatics stress for bringing reduction in the forming load [2], a practical application of the divided flow method to multiple-axis press has promoted manufacturing of the automobile parts of high accuracy [3].
Superposing the results of FEM on the experimental data in Fig. 14, it is found that the fracture compression ratio increases with increasing radius of the punch.

Although a reduction of the switching losses is welcome, the extremely high current of the applications makes the conduction performance more important than the switching in this application.
It is also important to remember the fact that the data presented in Table 1 shows the SEB voltage limit, so more careful study is mandatory to obtain the real SE degradation limits that will meet mission specifications.