Search results

Eckert et al. [11] have observed 20at% solubility; while Gu et al. [10] have reported 10at%.
Mater Sci. 46 (2001) 1–184 [7] El-Eskandarany, M.

Liang et al. found that the softening caused by DRX resulted in the transition from mild to severe wear of AZ31 alloy [9].
Somekava et al. also identified the relationship between surface temperature, subsurface microstructural evolution and wear resistance in pure Mg and Mg-Y alloy [10].
El-Morsy: Mater.

Magnesium alloy powder (Mg > 94.0%, Al ~ 2.5%-3.5%, with average particle size 86.4 μm) and chromium carbide powder (Cr3C2, purity > 99%, with average particle size 48.22 μm) were used as sintering additives.
Atom % C O Mg Al Si Cr Point 1 10.44 45.15 12.95 1.32 29.56 0.57 Point 2 28.85 17.83 9.16 1.19 42.96 Point 3 20.09 27.09 14.57 1.30 35.88 1.07 Fig.4 shows schematic configuration of sintering silicon carbide with Mg-Cr3C2 composite additives.
Xue, H.El Kadiri, M.F.

Positive ions (Na+, K+, Li+, Ca2+, Ba2+, NH4+, and H3O+) must be present in the framework cavities to balance the negative charge of Al in the four-fold coordination [3].
This is caused by the high content of silica in the sample that changed the ratio of Si /Al.
El-Eswed, M.

Vatne, et. al.
An essential component of the model introduced in this communication exploits a quantitative model for the coarsening of subgrain structures introduced by Holm et al. [5] which in turn built on earlier work on abnormal grain growth [6].
El-Dasher, S. , K.

Owais et al. [1] stated that the air that was present inside the PCM coated composite affect thermal conductivity of fabrics.
On the other hand, Mao et al. reported that [12] there was a little change in fabric density and decreasing of thermal conductivity due to the effect of hydro entangling a wool web on to the surface of a knitted spacer fabric.
El Rhafiki, and Y.

. : Nat Mater Vol. 4(7) (2005), p. 518 [2] Kuboki Y, Takita H, Kobayashi D, Tsuruga E, Inoue M, Murata M, et al. : J Biomed Mater Res 1998 Vol. 39(2), p. 190
[12] Moore MJ, Jabbari E, Ritman EL, Lu L, Currier BL, Windebank AJ, et al. : J Biomed Mater Res A Vol. 71(2) (2004), p. 258

The transitional period of friction is usually influenced by microstructure and physical properties of matrix, phase transformation and transfer, temperature and ambient condition et. al., as mentioned in detail in the Ref. [5].
In these areas, a tribo-chemical reaction obviously happened due to frictional heat and surface shear stresses, which is quite different from the thermal reaction of Ti3SiC2, and some products may be different from which observed by Sun et. al. [4].
El-Raghy, P.

We are also beginning an analysis and comparison of our simulation with Al thin film experiments in collaboration with K.
El-Dasher, K.
Barmak et al., Proc MRS (2004), to appear

Development and verification of a thermal model of lakes used with water source heat pumps[G]//ASHRAE Trans, 1990, 96(1):574-582 [2] Chiasson A D, Spitler J D, Rees S J, et al.
Ecological Modelling, 2001, 136(1): 67-80 [7] Yeates P S, Imberger J, El-sadek A, et al.