Search results

Semiconductor silicon is one kind substrate material that widely used in integrated circuit and microelectronic technology.
Discussion In the microwave, millimeter-wave circuit design, it usually adopts substrate materials with higher relative dielectric constant, and the thickness of substrate requires thinner with the frequency increasing; When PCB layout is fixed, change the thickness of substrate, the bandwidth of band-pass filter narrowed gradually as the thickness decreasing, the loss of the microstrip band-pass filter increased as the loss tangent increased; when take silicon as substrate, the center frequency of bandpass filter decreases continuously as the doped concentration increasing.
Acknowledgements This work was financially supported by the National Natural Science Foundation of China (61077037) and Henan Basic and Advanced Technology Research Program (102300413214).
Yoon: Applied Surface Science Vol. 154-155 (2000), p. 478 [6] V.K.
Prijić: Serbian Journal of Electrical Engineering Vol. 1 (2004), p. 237

With higher values in medicine, ornamentation and food, Lilium regale is an important breeding material and a rare wild flower germplasm resource.
Materials and methods Research site The research site is the arid valley in the upper reaches of the Minjiang River between the Tibetan plateau and Sichuan Basin, situated at latitude 103°10' N and 103°54'N and longitude 31°15'E and l32°32' E.
Acknowledgements The research work is financially supported by the Foundation of Key project of Natural Science of Sichuan Provincial Department of Education (11ZA179), of Key Laboratory of Southwest China Wildlife Resources Conservation (Ministry of Education) of China West Normal University, P.
Elora of China14 [M].Being: Beijing : Science Press.1980:124
Journal of Yangling Vocational & Technical College,2002 (1): 12-15

For the material of the spray boom is steel, the model’s parameter was defined as: Density is 7.85×103 (kg/m3), Elastic modulus is 2.07×105 (MPa), Poisson ratio is 0.3.
Ackonwledgements This work was financially supported by Special Fund for Agro-scientific Research in the Public Interest(201203025-04), Jiangsu Key Technology Support Program(BE2011334), National Fund of Transformation for Agricultural Science and Technology Achievements(2012GB2C100154), Key University Science Research Project of Jiangsu Province(10KJA470007), A Project Funded by the Priority Academic Program Development of Jiangsu Higher Education Institutions (PAPD 2011 NO.8).
Journal of Agricultural Engineering Research, Vol. 19(1974), p. 117-129
Advanced Materials Research, 2014, 900: 742-745.

The materials have same properties in each direction, elastic modulus is 2.06×105 MPa, Poisson ratio is 0.3 and yield strength is 235MPa.
Flexure Deformation Because the web of castellated member is variable cross-section, calculations of stress and deformation are problems that are difficult to be solved in material mechanics.
Science Press [S], 2002.
Heilongjiang Science and Technology Pess [M], 2000.
Journal of Constructional Steel Research, 1984,4(4): 295-315.

Effects of phosphorus-doping on the microstructures, optical and electric properties in n-type Si:H thin films Jian-Ning Ding a, Feng Ye b, Shu-Bo Wang c, Ning-Yi Yuan d * Center for low-dimensional materials, micro-nano devices and system, Changzhou University, 1 Ge Hu Road, Changzhou 213164, Jiangsu, China Key Laboratory of New Energy Source Changzhou 213164, P.
So, nc-Si:H films will be a good material applied in many optoelectronic devices, such as solar cells and thin film transistors (TFTs) [1,2].
Acknowledgment This work was supported by Key Programs for Science and Technology Development of Jiangsu (BE20080030, BE2009028), New Century Excellent Talents (NCET-04-0515), Qing Lan Project (2008-04).
Journal of Vacuum Science And Technology. 2006, 1672-7126

Materials and Methods Huadian oil shale was selected as the absorbent sample in the test.
The structure of adsorbent hole was roughly the same after the same modification method, and oil shale char’s internal water, volatile matter, fixed carbon and other material was separated after combustion process.
Environmental Science and Technology, Vol. 29 (1995), p. 1879 [8] T.
Journal of Colloid and Interface Science.

The material of tubes was 18-8 Austenitic Stainless Steel before 1968. 18-8 Austenitic Stainless Steel was replaced by annealed Inconel-600 Alloy because the chloride corrosion stress can cause the break accident and replaced by Inconel-690 Alloy after 1990.
The material of tube-sheet is high strength low alloy steel, and the processing technology is forging.
Atomic Energy Science and Technology, Vol. 42, pp. 556--561 (Suppl., 2008) [7] Song, J.K., Xue, S.L., Yao, Q.F.: Numerical Simulation of Stress and Strain of Tube Sheet and Heat-Transfer Tubes.
Journal of Harbin Engineering University, Vol. 30, pp. 639--43 (2009) [8] Jin, T.: Influence on Stress of Lower Assembly with Different Steam Generator Partition Plates Simplification.
Atomic Energy Science and Technology, Vol. 42, pp. 695-699(Suppl., 2008) [9]Dong, J.

In the actual manufacturing industries, some methods are used to check the NC code, such as cutting the materials that easy to be cut instead of workpiece and using track display method to detect the tool path [1].
Simulation Results In the virtual simulation process, it needs to conduct a Boolean operation on the workpiece and refresh the screen during the material removal process.
Acknowledgments This work was supported by the Science and Technology Planning Project of Guangdong Province(No.2013B090500125 , No.2013B090500037) , and the Postgraduate Demonstration Base Project of Department of Education of Guangdong Province (No.2013JDXM29), and the Introduction of Innovative R&D Team Program of Guangdong Province (No.201001G0104781202).
University of Science and Technology of China, 2004
[2] Tai Yong Wang, Xiao Bin Wang and Guo Feng Wang et al.: Journal of Southwest Jiaotong University Vol.558-561(2003), p.5

Acoustic emission, which is produced by the micro-cracks occurrence or growth, is a ubiquitous phenomenon associated with brittle fracture in many materials, including rock and concrete [1].
Sample Material and Experimental Technique Test specimens and loading.
Acknowledgements The work was funded by the China National Natural Science Foundation (50474017 and 50574022).
Lee: International Journal of Rock mechanics & Mining Science Vol. 41 (2004), P. 1069-1086

To eliminate these non-challant attitude HEI’s should emphases to promote the so-called 3r’swhich stands for Reduce, Reuse and Recycle, Even though 3r’s has no specific definitions, but nevertheless many researchers and authorities have come up with different definitions. 3r’s can be said to be an integrated tool designed from waste management hierarchy, which is used to minimize the volume of any unwanted bye product, and reuse of any product or material in it is present form, as well as the recycling which specifically involves the changing of composition or properties of any given materials in one way or the other for a greener environment. 2.
Lamoreaux, ‘Science education and sustainability initiatives: A campus recycling case study shows the importance of opportunity’, International Journal of Sustainability in Higher Education, vol. 4, no. 3, pp. 218–229, Sep. 2003
Kemp, ‘Recycling at student halls of residence: a case study for the University of Southampton’, presented at the Global Waste Symposium – Promoting Technology and Science Innovation, Copper Mountain, Colorado, USA, 2008, pp. 162–163