Search results

The coolant of the ADS is liquid lend-bismuth eutectic, which is a special material.
Acknowledgement Fund Project: Supported by the "Strategic Priority Research Program" of the Chinese Academy of Sciences（XDA03040000）.
Nuclear Science and Engineering, 2010, 30（3）, 239-243
Journal of Nuclear Materials, 2011, 415, 404–414

Conductive composite material was applied as sensor element.
Acknowledgements This work is supported by the National Natural Science Foundation of China (Grant Nos.: 50976006, 11102005) and Program for New Century Excellent Talents in University (Grant No.: NCET-10-0006).
Gandhi, High-sensitivity, surface-attached heat flux sensors, Microelectronics Journal. 30 (1999) 1163-1168
Diller, A direct-measurement thin-film heat flux sensor array, Measurement Science and Technology. 21 (2010) 1-8
Fabrication and calibration of Cu-Ni thin film thermocouples, Advanced Materials Research. 512-515 (2012) 2068-2071.

The material and structure of SSD The material of self-switching device usually is InGaAs/InP and InGaAs/InAlAs, which has modulation-doped quantum well structure[5].
The material we used in this paper was InGaAs.
Journal of Physics: Condensed Matter, 2008, 20: 384203
Chinese Science Bulletin, 2011, 56: 2206-2209
Science Press. (1997, In Chinese) [7] Kunyuan Xu, Gang Wang, Song A M, etc.

Introduction High nitrogen steel was a good mechanical properties and corrosion resistance steel, which is the new material of the most value in the metallurgical field in 21th century.
The raw materials are ferromanganese, ferrochrome and SPHC, and it is required to weigh accurately with electronic balance.
Acknowledgements This work was financially supported by Hebei Science and Technology Plan Program (10215116D) and the National Natural Science Foundation of China (50974051).
The Chinese Journal Of Process Engineering, 8(1),(2008), P.243-246.

The concrete material of the dam and was assumed to be homogeneous and linear-elastic.
The assumed properties of material in three different zones are indicated in Table 1.
Fig. 1: (a) The view of the dam and (b) the main dimensions of the cross section of the dam with points selected for dynamic analysis Table 1: Material properties of the dam Part of the dam Elasticity modulus [GPa] Poisson’s ratio [-] Mass density [kg/m3] Fundation zone 32 0,2 2500 Shell zone 29 0,2 2280 Crown zone 27 0,2 2160 For calculations the ABAQUS program was used [6].
Dulińska: Importance of ground motion spatial variability effects on earth dam, International Journal of Earth Sciences and Engineering, vol. 05, no. 01 (2012), p. 1-9
Fabijanska: Large-dimensional Shells under Mining Tremors from Various Mining Regions in Poland, World Academy of Science, Engineering and Technology, no. 59 (2011), p. 1443-1450.

In China, Tianjin University, Hunan Institute of physics, and Chinese Academy of Sciences Institute of acoustics have all developed mature products in film thickness measurement with a larger scale (above 1mm) has developed a mature product.
Among the layers and plates, the upper plate can be produced by iron nickel alloy material with low temperature coefficient, while the material of inner and outer insulating layers on measuring head is chosen as PTFE, the thickness of which should be as small as possible under the processing conditions permit.
This kind of sensor can be used for the detection of thin non-metallic material thickness, and in dynamic measurement and the static measurement applications.Through precise capacitance calculation, it has been found that additional capacitance caused by the edge effect is large, which has the very big relationships with plate distance and plate thickness.
The Huazhong University of Science and Technology 2006 [2] Xi-Fu Qiang, Sensors.
Journal of Liaoning College of Technology. 1994,14(3):80～83 [14] Yi-Qing Zhu, Jian-Hong Xu.

Ger 3,c 1Department of Power Vehicle and Systems Engineering, Chung Cheng Institute of Technology, National Defense University, Taoyuan, 335 Taiwan 2Graduate School of Defense Science, Chung Cheng Institute of Technology, National Defense University, Taoyuan, 335 Taiwan 3Department of Applied Chemistry and Material Science, Chung Cheng Institute of Technology, National Defense University, Taoyuan, 335 Taiwan akhou@ndu.du.tw, bc31010401@ndu.edu.tw, cmdger@ndu.edu.tw Keywords: Ni-W alloy, Pulse-electroplating, Composition, Corrosion resistance.
Ibl, influence of charge and discharge of electric double-layer in pulse plating Journal Of Applied Electrochemistry, 10(1980)775
Liu, Effect of W content on the structure and corrosionresistance of Ni-W alloy plates, Rare Metal Materials and Engineering 37(2008)130-134

Besides, the generation velocity of the condensation (nucleation) centres as known is in proportional to the probability of its generating: I= A1 exp (∆G /RT), where ∆G is Gibbs energy of the nucleation forming and the velocity of the material delivery to the condensed centre U= A2 exp (Eη /RT), Eη –the energy of the viscose flow, the energy of material transporting from initial phase to the nucleus surface.
Armstrong, Journal of Vacuum Science and Technology B, 13 (1995) 88 [4] J.
Goodhew, Journal of Crystal Growth, 120 (1992) 84 [5] T.B.
Joyce, Journal of Crystal Growth, 105 (1990) 299 [6] T.A.
Lioubtchenko, Applied Surface Science, 100-101 (1996) 169

Numerical Simulation of Inner Flow Yield of Turbulence Generator of Papermachine Headbox and Structure Optimal Design Shunli Houa, Xiongbo Sub College of Papermaking Engineering, Shaanxi University of Science & Technology.
Choose liquid water and keep the default values of other parameters, according to the characteristics of the new kind of material pulp density of 980kg/m3.
Select the phase properties of the mixture of two substances, the first phase is water, the second phase is new material.
Journal of South China University of Technology( Natural Science), 2002, 30(6):76-80
Journal of Korea Technical Association of the Pulp and Paper Industry, 2004, 36(5):1-10

But it was lower than the data reported by Nevin and Rajamohan that the polyphenol content of VCO was 80 mg/100g oil ,which was due to the materials we used were the white coconut but what they used were the meat with the seed coat in which contains a lot of polyphenol.
Á.Sanromán: Journal of Food Engineering.
Robert: LWT-Food Science and Technology.
Journal of Wuhan Polytechnic University.
Vol.24(1989),p. 659 [9] Rui Li, Qiuyu Xia, Songlin Zhao: Journal of the Chinese Cereals and Oils Association.