Search results

Szabó, "Segregation in Nanostructures" in "Advances in Nanophase Materials and Nanotechnology" Vol.
Journal of Appl.
Sepiol, Science, 306, 1913-1915 (2004) [15] D.L.
Thomas, Metals Materials and Processes Vol. 11, (1999), p. 217 [18] U.
Beke) special issue of Journal of Metastable and Nanocrystalline Materials, Vol. 19 (2004), p. 107 [25] C.

Abstract: This article presents a broad review of long persistence (LP) materials that are a special kind of photon energy storage and conversion materials.
Selection of Host Materials 3.2.
Multiple Center-doped Materials 4.
Selection of Host Materials: Host materials are of critical importance for long persistent phosphors.
[68] Chung-Hsin Lu, Shih-Yen Chen, Chia-Hao Hsu Nano sized strontium aluminate phosphors prepared via a reverse microemulsion route, Materials Science and Engineering B 140 (2007) 218–221

Materials and Methods Materials.
Key Engineering Materials 2013; 529-530: 29- 33
Materials Science and Engineering 2015; 47: 407–412
Key Engineering Materials 2012; 493-494: 551-555
Advanced Materials Research 2012; 445: 463-468

Because of wellbore volume restriction, to improve erosion-resisting capacity of tools, the high-strength material should be not only used, but the rational design of strings and tools should be also done to decrease the erosion and to improve the safety and reliability of the strings.
The temperature has no influence on packer material.
Considering the factors that cause half-way setting, this paper selects more suitable structure and material, thereby improving the reliability of the packer and avoiding half-way setting.
Xu: Journal of China University of Petroleum(Edition of Natural Science). 34 (2010) 76-79 [2] H.

Obviously, small deflection linear analysis method is unable to count in the effect of structural initial geometric defect, also non-linear and geometric effect of material is unable to be counted.
Depends on above result, only non-linear finite element method is applied to structure for plastic large deflection analysis, the practical loading condition could be more accurately shown, since geometric non-linear and material non-linear whole processes are all considered.
Steel web material is treated as plastic model; damage condition under complicated stress condition is distinguished by Von-Mises criterion.
Beijing: Science Press(1999). p. 52-55
Journal of Harbin Institute of Technology, Vol.5(2003)

Multi-fluid Mathematical Model For Blast Furnace and Its Parallel Solution Jiale Menga, Jianhua Shaob* and Aimin Zhaoc Research Institute of Metallurgy Engineering, University of Science and Technology Beijing, Beijing 100083, China aemail: jialemeng@yahoo.com, bemail: jhshao2004@163.com, cemail: aimin.zhao@ustb.edu.cn Keywords: blast furnace; mathematical model; simulation; CFD; parallel computing Abstract.
The blast furnace is a counter current chemical reactor, in which the lump solid materials are alternatively charged into the blast furnace from the top while hot air and pulverized coal are injected into the blast furnace through tuyeres that are set on the lower furnace wall.
Fig. 4 Mass fraction of iron bearing material in solid phase((a) Fe2O3 ; (b) Fe3O4 ; (c) FewO ; (d) Fe) Temperature of three phases are shown in Fig. 5.
Journal of chemical physics, Vol. 18(1950) , p. 1484

Technological system for weight measurements in a logistic warehouse BOŽEK Pavol1,a *, KORSHUNOV Alexander2,b and KOLLÁR Pavol3,c 1 Slovak University of Technology, Faculty of Materials Science and Technology Institute of Applied Informatics, Automation and Mathematics Hajdóczyho 1, 917 24 Trnava, Slovakia 2 Kalashnikov Izhevsk State Technical University, 7 Studencheskaya St. 426069 Izhevsk Russia 3 Technical University in Košice, Faculty of Electrical Engineering and Informatics, Department of Electrical Engineering and Mechatronics, Letná 9, Košice, Slovakia *apavol.bozek@stuba.sk, bkai@istu.ru, ckollar@kovalsystems.com Keywords: universal shelf stacker, control system, layers of control system, positioning, sensors, defragmentation Abstract.
On layer two can be connected master system for managing material, which is stored in USS and by its can be assigned the commands for moving the shelves into dispensing slot.
In: Journal of Electrical Engineering, 2014, vol. 65, no. 5, online, p. 277-282

The Construction of the Daily Life Mode of Low Carbon City Yu Dong1, a, Wei Dong2,b 1,2 School of Architecture, South China University of Technology; State Key Laboratory of Subtropical Building Science, South China University of Technology, Guangzhou, 510641China adongyu1228@163.com, barwdong@scut.edu.cn Keywords: Low Carbon City, Life Mode, Community, Public Participation.
For thousands of years, all the healthy society survived successfully have cultivated a sense of belonging and security, kept the confidence of meeting basic material needs, and provided the opportunity for each person to grow and express his or her own unique talents and aspirations.
In modern society, social progress is often reduced to material growth, especially in GDP growth.
In fact, after basic needs are met, the increase in material comfort has very low association with happiness of people.
Andrew: Journal of Social Philosophy Vol.34 (2003), p. 44-63 [3] M.

Materials and Methods Zone Specification.
Water quality of Jajrood River decreased in some points, especially in the vicinity of populated centers by entrance of residential sewage and increase of microbial and suspended material.
Fadaei-Nasab, "Water quality index as a simple indicator of watersheds pollution in southwestern part of Iran," Water and Environment Journal", 2012
Arbor Science Publishers Inc, 1978

Seibt2 1Institute of Solid State Physics, Russian Academy of Sciences, 142432 Chernogolovka, Russia 2Georg-August-Universität Göttingen, IV.
Acknowledgements The work was supported in part by research program “Physics of novel materials and structures” of Russian Academy of Sciences and by the President Grant NSh-884.2014.2.
Vanhellemont, Formation Energy of Intrinsic Point Defects in Si and Ge and Implications for Ge Crystal Growth Electronic Materials and Processing, Journal of Solid State Science and Technology, 2 (2013) 104-109