Search results

Introduction High temperature applications require new categories of structural materials with high toughness and hot corrosion resistance in order to increase the operating temperatures.
Since the last ten years, niobium alloys are considered as a real potential material allowing the use of the refractory alloys in high temperature applications.
The alloying additions of the niobium solid solution decreases the solubility of tin (3.7 at.% ) in bcc niobium as compared to 6at% in pure Nb at 1200oC according to the Nb-Sn binary [[] C.Toffolon, C.Servant, J.C.Gachon and B.Sundam, Reassessment of the Nb-Sn system, Journal of phase equilibria, Vol.23 N°2, 134-139, 2002. ].
They would like also to thank the common service of microscopy and microanalyses (SCMEM) of the Faculty of Sciences and Techniques of Nancy (France) for its help for microscopic observations.

Deposition of the coating material on a solid surface generates an interface.
Materials and Methods Glass beads, with size range between 1.68 and 2 mm, were chosen as nucleus in the coating experiments, due to the high surface energy of the glass [7].
Donida and A.M.M Marques: The Canadian Journal of Chemical Engineering Vol. 87 (2009), p.695
Neumann: Advances in Colloid and Interface Science Vol.81 (1999), p.167.

Materials Science and Engineering: A. 2001.
Rigaku Journal. 2011.
Material Sci.

The northern Shaanxi is located in the center of the Ordos basin in the Mesozoic era, where deposited a set of thick clastic material of river-lake facies.
Malan loess is the first layer of typical loess on the top, which is a set of uniform loose material, light in color, corresponding to last glaciations.
At present, this type of landslide is in an extra-stable state, the main reason is that after a long time of erosion, the residual sliding deposits have left a little, even the most sliding bed are outcropped, therefore, there are no material for revival.
Acknowledgements This work was financially supported by the Natural Science Foundation of China (No.
Journal of engineering geology. 2007,15(4),500-505.

The material from riser to ring header were replaced by 316NG.
The category A with 316 stainless steel material is only 2.63%.
The other 10 segments with non safety significant welds are risers of loop A and B that the pipe materials are IGSCC resistant 316 stainless steels.
Acknowledgement The financial support given by the National Science Council of Taiwan is gratefully acknowledged.
[16] Yao J.C., The applications of probabilistic risk assessments in Taiwan nuclear power plant (in Chinese), Journal of TAIPOWER Nuclear Energy, (1998)

However, special attention should be paid to security of structures and materials of featured landscapes while expressing innovation.
As shown in figure 12, the outdoor sculpture made from old mining production machine materials in Deutsches Bergbau-Museum Bochum has added interest to space while leading people to review the vigorous mining industry.
Therefore, security is reflected in many details of landscape design, including steadiness of structures of building entities, whether plants near roads are thorny and easy to hurt people or not, whether the depth of water lies within the safe value or not, whether appropriate materials have been used in paved facilities and featured landscapes on the square or not, whether there is a separation of vehicles and people on roads or not, whether the roads are anti-skid or not, and whether the scope of lighting is in the estimated scope or not, etc
[2] Dequn Zhou, Ruyin Long:Issue of Sustainable Development of China’s Mining Cities and Way Out (a fund program: a program funded by Natural Science Foundation of China),Journal of China University of Mining & Technology(Social Science), 3(2001) .

Stress Corrosion Cracking (SCC) of Nickel-base Weld Metals in PWR Primary Water Ru Xiong1,2,a, Yingjie Qiao1,b and Guiliang Liu2,c 1 School of Materials Science and Chemical Engineering, Harbin Engineering University, Harbin, 150001, China. 2 National Key Laboratory of Reactor Fuel and Materials, Nuclear Power Institute of China, Chengdu, 610041, China.
These materials began to exhibit extensive PWSCC at increasing rates in the early 1970s.
Subsequently, PWSCC was observed in more experiments; these early tests were conducted with wrought materials.
Subsequently, the SCC of Alloy 600 welding materials (e.g.
Wrought materials have generally equiaxed shapes of grains.

Compacted materials on the surface were detected via the analysis of deformed rings.
The measurement was performed by the diffractometer PHILIPS PW 1710 at Faculty of Materials Science and Technology in Trnava.
Even conditions of materials after soft annealing affects total conditions of tautness.
Grozav, Experimental device for practicing routines of machine tool precision measurement, Academic Journal of Manufacturing Engineering. 13, (2015), pp.39-44 [10] J.
Derbas, Investigation Of Defects In Forging Tools By Nondestructive Detection Method, Metal, 22nd International Conference On Metallurgy And Materials. (2013), pp. 485-490 [14] A.

It is to strengthen design of tunnel water ecological implementation, including the optimization design of tunnel lining structure, lining the choice of waterproof materials, ecological environment protection under conditions of controlled drainage design.
In the drain near the tunnel entrance or in the pH value adjusting groove is provided with oil absorbing material to absorb oil of the construction waste water.
Chinese Journal of rock mechanics and engineering, Vol. 24(1) (2005), p. 121-127.
Environmental science and management, Vol. 35(7) (2010), p. 188-194.

Main reason for this is that chloride exists in BF raw material and fuel.
In order to suppress abnormal corrosion of the gas pipeline system, analysis and study on corrosion mechanism of bellow compensator of gas pipeline is carried out to improve material and structure of stainless steel bellow compensator.
Material of bellow compensator is improved to stainless steel Incoloy825, which can prevent corrosion due to chloride ion, instead of austenite stainless steel 316L (00Cr17Ni14Mo2); polyethylene resin anti-corrosion paint is sprayed at the inner wall of the gas pipeline to separate metal pipeline and acid corrosion medium in order to suppress abnormal corrosion.
Acknowledgments This work was financially supported by the “11th Five Stage” National Science and Technology Support Plan Foundation (2006BAE03A10).
Journal of Iron and Steel Research International, Vol. 16 (2009), n.