Search results

For truly comparing with experimental results, values of section parameters and material strength are as the same as those in test [8] and their values are as followings: 2 2 2 2 0 0 27.7 , 337 , 354 , 1000 , 224 , 616 c a y s s f � mm f � mm f � mm l mm h mm A A mm' = = = = = = = 2 2 942 , 540 , 26 , af af s A A mm A mm a mm '= = = = 0 325 e M � mm = = The following are the main solving steps: 1 0.5 2.01 1 c cf A � ζ = = > , taking 1 1ζ = ; Slenderness ratio 0 4 15 l h = < , taking 2 1ζ = ; 2 0 1 2 0 0 1 1 1.0 1400 l e h h η ζ ζ   = + =     .
References [1] ACI 318-83: Building Code Requirements for Reinforced Concrete, American Concrete Institute, Detroit Michigan (1983) [2] ECCS: Composite Structure, London and New York, the Construction Press (1981) [3] LIU Guochun: Steel reinforced concrete design guide CN-78 in the Soviet Union (1983) [4] JGJ138-2001/J130-2001: Technical specification for steel reinforced concrete composite structures, china building industry press, Beijing (2001) [5] FENG Naiqian, YE Lieping: Calculating criteria and illustration of steel reinforced concrete composite structures, Japanese architecture association, the atomic power press, Beijing (1998) [6] ZHAO Hongtie: Steel-concrete composite structure, science and technology press, Beijing(2001) [7] LI Meihua, LI Hui: Calculation of bearing capacity for steel reinforced concrete column subjected to large eccentric compression load, Journal of zhejiang university of technology, Vol. 12, No.4 (2004), p.464-468 [8] Yasushi NISHIMURA

Experimental Study on Dynamic Behaviors of Concrete Bridge in China Existing Railway Speed Increase to 200~250km/h Penghui Liu1, Yiqian Yang1, Jingchuan Yao1, Wei Wang1, Zhensheng Dong1 Railway Engineering Research Institute, China Academy of Railway Science, 100081 Beijing, China email: liupenghui@rails.com.cn, yangyiqian@rails.com.cn, yjcwxj@rails.com.cn, wangyawei5241@126.com, dzhsheng007@163.com KEY WORDS: Bridge; Dynamic Behaviors; Speed Increase.
Because of the low speed early, which of the passenger train is less than 120km/h and the freight train is not ruled in design code with the operating speed of 60km/h, the bridge were designed to fulfill the requirement of ultimate capacity and save material.
Journal of JSCE, 1976, 256(12):35-47

Introduction With the development of science and technology, light-emitting diode (LED) technology is maturing, with many kinds, especially in a very wide range of its application.
Seen in figure 1[5], no matter what material of the LED, and it has a relative light intensity which is the strongest (light output max).
Journal of Beijing Forestry University, 2002, 24 (5) ，pp.235-242.

Study site Fankou mine locating in Shao Guan, Guangdong Province, China, is an important industrial raw material base in China and the largest lead-zinc mine of Asia.
Fig. 2 Tracer breakthrough curve at 203/fk1 after tracer injected into CK48 Fig. 3Tracer breakthrough curves after rhodamine injected into CK55 6.5 hours after rhodamine injected into CK55, tracer first detected in WS-2, with four waves in the breakthrough curve; the breakthrough also occurred in 212/FK2 and 214/SK15 (Fig3.), the maximum concentration occurred 12.5 and 17.0 hours separately science the injection. the tracer decays rapidly aftrer the maximum concentration.
Hydrogeology Journal (2008) 16: 951–967 [5]Nico.G. 2007.

The Prediction for Favorable Areas of Hot Dry Rock Exploration in the Northern Part of Songliao Basin Xiaoxiong Wu1, a, Shangming Shi1, a, Pan Zhao1, a, Huabin Wei1 a, Liang Zhang1, a and Xuemin Bai1, a 1Northeast Petroleum University, Earth Sciences, Heilongjiang, Daqing.163318, China; a xiaoxiong_wu@163.com Keywords: Songliao Basin, geothermal resources, Hot Dry Rock, geothermal gradient abnormal Abstract: After years of research about the geothermal resources in the northern part of Songliao Basin, preliminary results have been achieved in the exploration and development of middle-shallow layer geothermal resources and oilfield production water geothermal resources.
Meanwhile, the deep fracture deeply cut earth crust, become weak belt, and become the rising channel of mantle material and the heat flow, create good conditions for the base hack, intrusion, convection of magma and formation of Hot Dry Rock, while the deep fracture controls volcanic activity of the basin and the basin basement, and make up the fracture net connected the upper mantle heat source together with fracture in basin.
Journal of Daqing Petroleum Institute, 1998, 22( 4) : 77~79

The flywheel workload can be increased using fiber-reinforced material, which increases the energy density.
Maximum rotational speed with objectives to achieve high utilization without exceeding maximum material stress determines the required moment of inertia and hence its geometry.
The ecological assessment considers the overall material and energy flows and additional environmental pollution over the product life cycle.
CTI-Symposium Innovative Automotive Transmissions, Hybrid & Electric Drives, Dezember 2008. [8] Torsten Felzer and Rainer Nordmann, "Evaluating the Hands-Free Mouse Control System: An Initial Case Study.," in Lecture Notes in Computer Science - Computers Helping People with Special Needs.
Montague, "Test and Theory for Piezoelectric Actuator-Active Vibration Control of Rotating Machinery," Journal of Vibration and Acoustics, vol. 113, pp. 167-175, 1991. [20] Alireza Alizadeh. (2005) Robust Control for Active Vibration Damping of Elastic Rotors with Piezo Stack Actuators (in German), Dissertation, TU Darmstadt.

Maximum Power Point Tracking Methods The efficiency of the PV cell depends not only on the material and technology but also on the environmental factors like temperature and insolation.
Energy Convers, vol. 22, no. 2, pp. 439–449, Jun. 2007 [10] Joe-Air Jiang, Tsong-Liang Huang, Ying-Tung Hsiao, Chia- Hong Chen, Maximum Power Tracking for Photovoltaic Power Systems, Tamkang Journal of Science and Engineering, 2005,Vol. 8, No. 2, pp. 147-153

The chronoamperometric technique is an effective method to evaluate the electrocatalytic activity and stability of electrode material.
Acknowledgements The authors wish to thank the following project for financial support:(1) Natural Science major basic research projects of Jiangsu Higher Education Institutions (08KJA480001); (2)Applied Research Plan Projects of Nantong City (No.K2009007); Nantong City Key Laboratory of Fuel Cell (No.
Vol.9 (2007),p.2654 [6] A.Varesano,A.Montarsolo and C.Tonin:European Polymer Journal Vol.43 (2007),p.2792 [7] H.Tao,A.L.Yarin and D.H.Reneker:Polymer Vol.49(2008),p.1651 [8] F.P.Hu and P.K.Shen: J.

It has a unique advantage in its research on the motion and interaction of loose bulk material through the simulation analysis of the clearing procedure in precision metering device with combination inner-cell, the waterproof pillar to coal seam mining goaf beside large fault and jacked piles during installation in sand.
[2] Xiaojing Feng, Xin Yang, Yongying Sang, etc., Situation of corn precision seeding machine [J], Jiangsu Agricultural Sciences 4 (2010) 422-424
Forssberg, Computer simulation for particle packing phenomena [J], Journal of The Chinese Ceramic Society 31(2) (2003) 169-178

The research on Optimization neural network structure parallel genetic algorithm Mingyan Yu1,a , Ying Yan1,b , Haiyuan Liu2,c, HeCai Zhi1,d 1Information Technology Department,Guangdong Communication Polytechnic ,Guangzhou,510800,China 2College of Information Technical Science, Nankai University, Tianjin, 300071, China aYu_mingyan@163.com, byang_anny@163.com, cliuhaiyuan@nankai.edu.cn, dzhihc@163.com Keywords: Neural network, structural optimization, LMBP algorithm, symbiotic parallel genetic algorithm Abstract: This paper combines the global optimization ability of the symbiotic parallel genetic algorithm and the local optimization ability of the improved LMBP algorithm to research,proposes an neural network structure optimization symbiotic parallel genetic algorithm and to testify the correctness and validity of this algorithm by the simulation experiments.
Here we should make appropriate modifications to the improved LMBP algorithm which have proved successful and mentioned in the reference material [8].
Zhang Jinwei,Geophysical Research Institute,Shengli Oilfield Company,SINOPEC,Dongying City,Shandong Province ,257022,China;Seismic weak information separation by alternating projection neural networks[J];Petroleum Geology and Recovery Efficiency;2009-06 [9]Hamed Shah-Hosseini, The intelligent water drops algorithm: a nature-inspired swarm-based optimization algorithm, International Journal of Bio-Inspired Computation (IJBIC), vol. 1, 2009