Photoelastic Investigation of Friction and Residual Stress in Shrink-Fitted Shafts and Hubs

Abstract:

This paper describes initial investigations into the use of frozen-stress photoelasticity to study the development of slippage within shrink-fitted shaft/hub pairs, with the aim of studying the residual stresses remaining after partial slippage has occurred. Results to date show the feasibility of measuring the shear stresses along the partially-slipping interface between shaft and hub.

• Periodical: Applied Mechanics and Materials (Volumes 1-2)
• Pages: 171-178
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.1-2.171
• Online since: September 2004
• Authors: I.A. Jones, Christopher E. Truman, Julian D. Booker
• Keywords: Photoelasticity, Residual Stress, Shrink Fit

References

[1] C. E Truman, A. Sackfield and D.A. Hills, Proc. IMechE, Part C: J. Mech. Eng. Sci., Vol. 216, No 11 (2002), p.1109.

[2] A. Sackfield, C.E. Truman and D.A. Hills. Proc. IMechE, Part C: J. Mech. Eng. Sci., Vol. 216, No 10 (2002), p.997.

[3] A. Sackfield, J.R. Barber, D.A. Hills and C.E. Truman, Eur. J. Mechanics, A/Solids, Vol 21, No 1 (2002), p.73.

[4] C.E. Truman, and J.D. Booker, Proc. 5th Int. Conf. on Modern Practice in Stress and Vibration Analysis, Glasgow, 9-11 Sept. 2003, publ. as Materials Science Forum, Vols 440- 441 (2003), p.447.

[5] K. Lingaiah and G. Gargesa, Exp. Mech., Vol. 16, No 2 (February 1976), p.75.

[6] F. Nakagawa, T. Sawa, Y. Nakano and M. Katsuo, Trans. ASME Des. Eng. Div., Vol. 105 (1999) p.65.

[7] N.V. Scurria and J.F. Doyle, Exp. Mech., Vol. 22, No 9 (September 1982), p.342.

[8] A. J. C. Lee, A photoelastic investigation of contact stresses between spheres under conditions of rolling with spin. PhD thesis, University of Nottingham, (1966).

[9] A. Triplow, I.A. Jones. and D.L. Chen, Proc. 4th Int. Conf. on Modern Practice in Stress and Vibration Analysis, Nottingham (2000) p.111.

[10] D.C. Ghiglia and M.D. Pritt, Two-dimensional phase unwrapping: theory, algorithms and software (Wiley, New York 1998).

[11] I.A. Jones and Wang, P. Complete fringe order determination in digital photoelasticity using fringe combination matching,. Strain, Vol. 39 (2003), p.121.

DOI: 10.1046/j.1475-1305.2003.00073.x

[12] I.A. Jones, Paper 260 in Proc. Soc. for Exp. Mech. Conf., Charlotte, NC, 2-4 June (2003).

[13] A.W. Fitzgibbon, http: /www. robots. ox. ac. uk/~awf/ellipse/fitting. zip.

[14] C. Chatfield, Statistics for Technology. 3rd ed., Chapman and Hall, London (1983).

[15] A.P. Boresi, R.J. Schmidt and O.M. Sidebottom, Advanced Mechanics of Materials. 5th ed: Wiley, New York (1993), pp.447-450.