Design of an Electric Control System for Plastic Pipe Automatic Conveyor Line

Rui Jiang; Hui Huang; Ying Zhang

doi:10.4028/www.scientific.net/AMM.220-223.863

Paper Titles

Design of Induction Motor Variable Frequency System Based on DSP
p.845

Single Neuron PID Adaptive Control for BLDCM Based on Algebraic Algorithm
p.851

Numerical Computation of Temperature in APU Compartment of Passenger Plane
p.855

Research on Lightweight Design Manual Piston Pump
p.859

Design of an Electric Control System for Plastic Pipe Automatic Conveyor Line
p.863

Structural Analysis of 1000MW Ultra Supercritical Boiler’s Steam-Water Separator
p.867

Experimental Study on Diesel Engine Emission with Mixed Fuel of GDE and Diesel
p.871

Research of Wet Gas Experimental Facility with Adjustable and Intermediate Pressure
p.875

Simulation Research on Fuzzy Adaptive PID Control of Variable Pump Control System
p.880

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 220-223Design of an Electric Control System for Plastic...

Design of an Electric Control System for Plastic Pipe Automatic Conveyor Line

Abstract:

In order to improve the degree of automation in plastic pipe production and save labor cost, this paper proposes a design scheme about the electric control system design of straight pipe automatic conveyor line. The Programmable Logic Controller (PLC) is the core control component in this system. This system can control the start and stop of production lines by applying communication between computer and PLC, change the number of each bundle of pipes, and monitor online the operation conditions of automatic transmission lines. Finally, actual operation of the system shows that it runs steadily, operates simply, and is highly automatic with low labor cost.