A Study of Heat Transfer Characteristics of LED Heat Sink and Graphite Heat Sink Process Technology Development

Abstract:

This study investigated the heat transfer characteristics of LED heat sink and the development process technology of graphite heat sink with micro-sized metal powders. Employing the reverse engineering technology, the three-dimension LED heat sink entity was rebuilt and the heat transfer characteristics of LED heat sink were analyzed by CFD numerical simulation and experimental measurement. The numerical results were validated with experimental results and it showed a good agreement. The experimental and simulation results showed that the heat dissipation of LED device could be removed by natural convection effectively. The difference between the maximum temperature and minimum temperature of cooling efficiency was 10°C. For the process technology development of LED graphite heat sink, the graphite powder, metal powder and resin were mixed in specific ratios. The vacuum casting, vacuum pressure casting and rapid die technology were used to manufacture LED graphite heat sink. The experimental results showed that the LED graphite heat sinks developed in this study have advantages of low cost, light weight and attractive appearance as compared with the heat sink of aluminum alloy, and the overall heat transfer capacity is still within acceptable range.

• Periodical: Applied Mechanics and Materials (Volumes 284-287)
• Pages: 819-823
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.284-287.819
• Online since: January 2013
• Authors: Shie Chen Yang, Tsuo Fei Mao, Tzer Ming Jeng, Sheng Chung Tzeng, Tzung Ying Shie, Chih Liang Chen, Po Tsun Chen
• Keywords: Graphite, Heat Sink, LED, Natural Convection

References

[1] K.L. Choi: J. Thermochemical Acta Vol. 455 (2007), p.344.

[2] D. Lu and C. P. Wong, in: Materials for Advanced Packaging, New York, Springer (2008).

[3] G. Ledezma and A. Bejan: Int. J. Heat Mass Transfer Vol. 39 (1996), p.1773.

[4] F. Harahap and D. Setio: Appl. Energy Vol. 69 (2001), p.273.

[5] R.T. Huang, W.J. Sheu and C.C. Wang: Int. J. Heat Mass Transfer Vol. 51 (2008), p.2368.

[6] L. Dialameh, M. Yaghoubi and O. Abouali: Appl. Therm. Eng. Vol. 28 (2008), p.2371.

[7] S. Yu, K.S. Lee and S.J. Yook: Int. J. Heat Mass Transfer Vol. 54 (2011), p.2499.

[8] N.T. Tran and F.G. Shi: J. Lightwave Tech. Vol. 26 (2008), p.3556.

[9] Y. Zhou, N.T. Tran, Y.C. Lin, Y. He, and F.G. Shi: IEEE Trans. Adv. Packag. Vol. 31 (2008), p.484.

[10] A. Christensen and S. Graham: Appl. Thermal Eng. Vol. 29 ( 2009), p.364.

[11] L. Yin, W. Yang, Y. Guo, K. Ma, S. Li, M. Chen, J. Li, and J. Zhang, in: Proc. IEEE 58th Electron. Compon. Technol. Conf., (2008).

[12] S.V. Patackar and D.B. Spalding: Int. J. Heat Mass Transfer Vol. 15 (1972), p.1787.