The Study of How to Extrude the Special Shaft Parts into Form

Abstract:

In this article, it mainly describes the use of extrusion production process as an example of the special shaft. It gives us a full analysis from the structure of the product, the material problems, the key technical problems needed to be solved, blank preparation processing and the process of extrusion forming. It also introduces the blank dimensions and the calculation method of the extrusion pressure. The method of blank lubrication processing and the process of designing extrusion mould.We are not unfamiliar with the center shaft of the bike. It is one of the important parts in bicycle bottom bracket. It is also a key part to determine the quality of the bicycle. Generally speaking, materials are used is 20 steel. The roughness of the surface is moderate. But the requirement of the product precision is high. We can get it by using mechanical processing method. But it is processing and the efficiency is low. While the utilization rate of mental material is low. So the production costs high. Because the parts production patch is large and the annual production is hundreds of thousands of pieces. In my opinion, it is more reasonable for us to adopt the technology of producing the parts with the cold extrusion precision molding process. Then we can save the materials, improve the efficiency of producing parts, lower the production parts and then meet the requirement of mass production.

• Periodical: Applied Mechanics and Materials (Volumes 401-403)
• Pages: 908-911
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.401-403.908
• Online since: September 2013
• Authors: Xi Ping Bai
• Keywords: Extrusion, Mould, Special Shaft

References

[1] Fuxiang, Tian. Shaft Parts Horizontal Floating Upsetting Mould [J]. Mould Indistry, 2004(8).

[2] Maoqing Zhang . The Design of Bicycle Crank Siamese Axis Cold Extrusion Mould [J]. Chinese Bicycle，1993(5).