The Research on Switch-Linear Hybrid of Precise Current Source

Abstract:

In this paper, a novel current control strategy of precise current source is presented, which combines switch power conversion mode with linear amplification mode. The linear power amplifier is used as the power converter in the current loop. The current controller is a double cascaded PI (DCPI) controller which is put up by the way of analog circuit, it can suppress the high frequency disturbance signal effectively. The switch-filter circuit can generate a special power supply for linear power amplifier, the voltage of this special power supply changes as the load voltage does. The topology of four-level H-Bridge works as the power converter of the switch power amplifier, the LC filter circuit can eliminate the current ripple caused by the PWM chopper.The simulation and experimental results verify that the Switch-Linear Hybrid (SLH) scheme is of high efficiency and output quality. The bandwidth of the precise current source is 5.4 kHz and the phase margin is 42 degree.

• Periodical: Applied Mechanics and Materials (Volumes 416-417)
• Pages: 559-564
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.416-417.559
• Online since: September 2013
• Authors: Li Yi Li, Qi Ming Chen, Jia Xi Liu, He Zhu, Guang Jun Tan
• Keywords: Double Cascaded PI, Four-Level H-Bridge, Precise Current Source, Switch Linear Hybrid

References

[1] H. Wenhua, M. Weiming and Z. Qianzhi, Switch linear hybrid power converter and its applications, in Industrial Electronics and Applications, 2008. ICIEA 2008. 3rd IEEE Conference on, 2008, pp.929-933.

DOI: 10.1109/iciea.2008.4582651

[2] Z. Qianzhi, Z. Kai and W. Jugui, A novel single-three phase inverter adopting CTA scheme, in Power Electronics and Motion Control Conference, 2000. Proceedings. IPEMC 2000. The Third International, 2000, pp.980-984 vol. 2.

DOI: 10.1109/ipemc.2000.884648

[3] Z. Qianzhi, H. Wenhua, W. Bin, and D. Mouzhi, Switch-Linear Hybrid Power Conversion (I) - The Topologies Based on Source Follower, in Industrial Electronics and Applications, 2006 1ST IEEE Conference on, 2006, pp.1-7.

DOI: 10.1109/iciea.2006.257380

[4] H. Wenhua, W. Bin, D. Mouzhi, and Z. Qianzhi, Switch-Linear Hybrid Power Conversion (II) - Typical Analyses in the Topology's High Efficiency, in Industrial Electronics and Applications, 2006 1ST IEEE Conference on, 2006, pp.1-5.

DOI: 10.1109/iciea.2006.257215

[5] X. Huan, J. Qian, R. Xinbo, and X. Xiaoling, Full Feedforward of the Output Voltage to Improve Efficiency for Envelope-Tracking Power Supply Using Switch-Linear Hybrid Configuration, Power Electronics, IEEE Transactions on, vol. 28, pp.451-456, 2013-01-01 (2013).

DOI: 10.1109/tpel.2012.2200109

[6] X. Xiaoling, R. Xinbo, X. Huan, and G. Junji, Feed-Forwarding the Output Voltage to Improve Efficiency for Envelope-Tracking Power Supply Based on a Switch-Linear Hybrid Scheme, Power Electronics, IEEE Transactions on, vol. 26, pp.2106-2111, 2011-01-01 (2011).

DOI: 10.1109/tpel.2011.2119494

[7] L. Xiaodong, K. Jingbo and L. Sucheng, An arbitrary waveform power amplifier adopting Switch-Linear Hybrid technology, in Electrical Machines and Systems, 2008. ICEMS 2008. International Conference on, 2008, pp.2159-2162.

DOI: 10.1109/icpe.2007.4692560

[8] L. Xiaodong, L. Shubo and S. Yanyan, An Arbitrary Waveform Generator for Switch-Linear Hybrid Flexible Waveform Power Amplifier, in Industrial Electronics and Applications, 2007. ICIEA 2007. 2nd IEEE Conference on, 2007, pp.2732-2736.

DOI: 10.1109/iciea.2007.4318909