Investigating the Use of Nanoscale Bilayers Assembly on Stainless Steel Plate for Surface Hydrophobic Modification and Condensation

Abstract:

This study investigated the use of nanoscale bilayers assembly for hydrophobic surface modification on stainless steel plate and its effect on condensation. This study first performed nanoscale bilayers assembly method, with the addition of a fluorosilane treatment using chemical vapor deposition (CVD), to modify the surface structure and thereby the wettability of the surface at 15, 20, and 30 bilayers. Experimental results showed 15 bilayers to be the optimal number of bilayers among the samples tested, resulting in the largest contact angle of 150° (compared to 70° on unmodified surface), corresponding to the highest surface hydrophilicity; however, beyond 15 bilayers there seems to be no significant changes or improvements to hydrophobicity. Visualization of the condensation process also indicated later formation of film condensation on superhydrophobic (15 bilayers) surface, and by tilting the condensation surfaces at 90°, the self-cleaning property of the superhydrophobic surface allows water droplets to roll off the surface due to gravity before formation of film condensation, while large water droplets still remain stuck on unmodified surface. Therefore, by allowing the condensation process on the superhydrophobic surface to continuously cycle back to droplet condensation, there is great potential for condensation enhancement on superhydrophobically modified surface.

• Periodical: Applied Mechanics and Materials (Volumes 423-426)
• Pages: 792-796
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.423-426.792
• Online since: September 2013
• Authors: Shen Chun Wu*, Dawn Wang, Sin Jie Lin, Chen Yu Chung, Yau Ming Chen
• Keywords: Condensation, Contact Angle, Hydrophobic Modification, Nanolaminated Assembly

References

[1] J. Bravo, L. Zhai, Z. Wu, R. E. Cohen and M. F. Rubner. Transparent Superhydrophobic Films Based on Silica Nanoparticles. Langmuir, Vol. 23 (2007) 7293–7298.

DOI: 10.1021/la070159q

[2] Mitzi, D.B. Thin-film deposition of organic-inorganic hybrid materials. Chemistry of Materials 13 (2001) 3283-3298.

DOI: 10.1021/cm0101677

[3] Quéré, D. Wetting and Roughness. Annu. Rev. Mater. Res. 38 (2008) 71–99.

[4] Forrest, E. Willianson, J. Buongiorno, L.W. Hu, M. Rubner, R. Cohen. Augmentation of nucleate boiling heat transfer and critical heat flux using nanoparticle thin-film coating. I. J. Heat Mass Transfer 53 (2010) 58-67.

DOI: 10.1016/j.ijheatmasstransfer.2009.10.008

[5] Wu, S.C., D. Wang, S. J. Lin, P.W. Ciou, C.Y. Chung, S.J. Su, Y. M. Chen. Investigating the use of nanoscale bilayers assembly on stainless steel plate for surface hydrophilic modification. Advanced Materials Research (2013), accepted.

DOI: 10.4028/www.scientific.net/amm.401-403.792