Typical Insulation Defects Simulation and Signal Characteristics Analysis of GIS Partial Discharge

Abstract:

Gas insulated switchgear (GIS) has excellent performances such as small area, not affected by atmosphere, high reliability. So it has been used more and more widely in the power system. However, But the partial discharge (PD) would occur because of insulation defect, PD will lead to the GIS insulation damage after a long time, and will lead to serious consequences without treatment in time, therefore, the PD detection is particularly important. Article simulates the high voltage conductor spikes, basin insulator metal particles on the surface and the shell spike the insulation of the three kinds of typical defects, using the pulse current method and ultrasonic method to test partial discharge signals and get the corresponding signal characteristics, which play a certain guiding significance for field applications.

• Periodical: Applied Mechanics and Materials (Volume 521)
• Pages: 394-398
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.521.394
• Online since: February 2014
• Authors: Kang Ning Wang*, Tian Zheng Wang, Jie Yan
• Keywords: Gas Insulated Switchgear (GIS), Insulation Defects, Partial Discharge (PD), Signal Feature

References

[1] Changchang Wang, Fuqi Li, Shengyou Gao: Online monitoring and fault diagnosis of electrical equipment , Beijing: publishing House of Tsinghua University, 2006: 100-201, in Chinese.

[2] Yuchang Qiu: GIS device and its insulation technology, Beijing: Water Resource and Electric Power Press, 1994: 34-89, in Chinese.

[3] Phil Bolin, Hermann Koch: Introduction and applications of gas insulated substation (GIS), IEEE Power Engineering Society General Meeting 2005, San Francisco, California, United States: IEEE, 2005, 920-926.

DOI: 10.1109/pes.2005.1489251

[4] International Electrotechnical Commission. IEC 60071-2. Insulation Co-ordination Part 2: Application guide. Switzerland. IEC Publication, 1996. 12. 1.

[5] Jisheng Li, Xuefeng Zhao, Jinggang Yang, ea al: Partial diacharge measurement and analysis of GIS typical defects, High Voltage Engineering, 2009, 35(10): 2440-2445, in Chinese.

[6] Bo Qi, Chengrong Li, Lishi Luo, et al: Experiment on the correlation between partial discharge and gas decomposition products in GIS, High Voltage Engineering, 2010, 36(4): 957-963, in Chinese.

[7] Bo Qi, Chengrong Li, Zhen Hao, et al: The surface partial discharge development phenomena and their characterisitics of GIS insulator surface' fixed metal particals, Proceedings of the CSEE, 2011, 34(4), 312-317, in Chinese.