Modeling and Predicting Surface Roughness for the Grinding Process

Xiao Ni Wen

doi:10.4028/www.scientific.net/AMM.599-601.622

Paper Titles

Numerical Investigation of Choking Cavitator Based on Orthogonal Experiment
p.603

Research on One Kind of Intellectualization High Accuracy Digital Adjustment Direct Source
p.608

An Inquiry into the Sustainable Development of Cellulosic Ethanol in Tianjin, China
p.612

Main Technologies of Life Support System of Evacuated Tube Transportation Vehicle Passenger Cabin
p.616

Modeling and Predicting Surface Roughness for the Grinding Process
p.622

A Band-Gap Voltage Reference for LDO Circuit
p.626

A Photovoltaic Soft Switching Boost Circuit
p.631

Calculate Formation Velocity from Vertical Seismic Profiling Data
p.639

Design of a 10MPa Nanosecond Gas Switch with Adjustable Gap
p.643

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 599-601Modeling and Predicting Surface Roughness for the...

Modeling and Predicting Surface Roughness for the Grinding Process

Abstract:

This paper proposes a new algorithm for predicting the cross-sectional surface roughness of the workpiece for the grinding process, which reduces three-dimensional modeling to two-dimensional modeling by virtue of the cross-sectional area of the undeformed grinding chip. Besides, this paper develops a search technique to figure out systematically the surface roughness in order to determine the final cross-sectional surface roughness produced by thousands of grinding wheel grains with randomly distributed protrusion heights. The simulated results are consistent with the measurement data, which proves the effectiveness of the proposed algorithm.