Measurement of Geometric Parameters for Cutting Tools Based on MATLAB

Lu Xiao; Yang Yi Teng

doi:10.4028/www.scientific.net/AMM.635-637.832

Paper Titles

Time Delay Estimation in Reverberant Environment Based on Acoustic Pyrometry
p.811

Application on State Evaluation of the Grounding Conductor Based on Fault Diagnosis Method
p.815

Calibration of Thermostatic Bath Used on Electronic Thermometer Verification
p.819

Ground-Based Videometric Method and System for the Real-Time Measurement of Aircraft Landing Track
p.824

Measurement of Geometric Parameters for Cutting Tools Based on MATLAB
p.832

Monitoring Growth Characters and Yield with Hyperspectral Remote Sensing in Wheat
p.838

The Application and Research of Order Analysis in Gearbox Fault Diagnosis
p.844

The Monitoring and Fault Diagnosis System for Controllable Pitch Propeller Based on LabVIEW
p.851

A Novel In-Line Fiber Mach–Zehnder Interferometer Temperature Sensor Made of Thermally Expanded Core Fiber
p.856

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 635-637Measurement of Geometric Parameters for Cutting...

Measurement of Geometric Parameters for Cutting Tools Based on MATLAB

Abstract:

In this paper, the MATLAB image processing technology has been adopted to obtain the contour of a turning tool with arc blade by binarization of the image, median filter as well as detection of the edge. Then curve-fitting method have been used to fit the contour of straight edge and arc-edge respectively. Finally, the nose angle of the cutter and the arc radius of the turning tool have been obtained by the analysis of fitting results of slope for straight edge and curvature radius for arc-edge. It is shown that the measurement of geometric parameters for cutting tools based on MATLAB not only has small measurement errors and high measurement efficiency, but also can be widely used to obtain tiny geometry parameters for tools with high precision.

You might also be interested in these eBooks

Advanced Design and Manufacturing Technology IV

View Preview

Info:

Periodical:

Applied Mechanics and Materials (Volumes 635-637)

Pages:

832-837

DOI:

https://doi.org/10.4028/www.scientific.net/AMM.635-637.832

Citation:

Cite this paper

Online since:

September 2014

Authors:

Lu Xiao, Yang Yi Teng

Keywords:

Curve Fitting, Geometric Parameters for Tools, Image Processing Technology

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

Citation:

References

[1] Zhang Bin, Wang Junyuan, Zhou Jing. Research on Measurement Technology of Tool Geometry Parameters Based on Image Processing [J]. Tool technology, 2010, 44(7): 101-104. (In Chinese).

Google Scholar

[2] Qiu Jiangping, Bao Min. Cutting Tool Geometry Parameter Measurement System Based on Image Processing [J]. Mechanical & Electrical Engineering, 2010, 27(6): 32-39. (In Chinese).

Google Scholar

[3] Zhang Qiang, Wang Zhenglin. Proficient in MATLAB image processing [M]. Electronic Industry Press, 2012. (In Chinese).

Google Scholar

[4] Chen Ying, Zhang Wei, Li Zhiwei et al. Angle Measurement of Linear Edges Cutting Tools Based on Image Process [J]. Tool technology, 2007, 41(5): 86-88. (In Chinese).

Google Scholar