The Casting Process Design and Simulation of the Front Wearing Plate of 10/8ST-AH Slurry Pump

Abstract:

The casting process design and simulation of the front wearing plate of 10/8ST-AH slurry pump were presented in this paper. The casting process design principle, process parameters, points of attention, and the simulation parameters were introduced. Huazhu CAE was used to simulate the casting process. The STL document used in Huazhu CAE was converted from the 3D moulding of the casting process using the Solidwork software. The simulation results and practical production showed that the casting process can reduce shrinkage defects of the casting.

• Periodical: Applied Mechanics and Materials (Volumes 66-68)
• Pages: 1724-1727
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.66-68.1724
• Online since: July 2011
• Authors: Ying Jie Yin, Yan Jun Han, Xiao Hui Zhi
• Keywords: Casting Process, Computer Aided Engineering (CAE), High Chromium Cast Iron, Simulation

References

[1] Craig I. Walker and Greg C. Bodkin: Wear Vol242 (2000), p.140.

[2] Dennis W. Hetzner and William Van Geertruyden: Materials Characterization Vol. 59 (2008), p.825.

[3] Liu H, Sakamoto Michiru, Nomura Mikio and Ogi Keisaku: Wear Vol. 250 (2001), P. 71.

[4] Bedolla-Jacuinde A, Correa R, Quezada JG and Maldonado C: Materials Science Engineering A Vol. 398 (2005), P. 297.