A Processing Approach Incorporating Copper Backing-Wheel Device in Submerged Arc Welding for Manufacturing Cryogenic Storage Tanks

Abstract:

A processing approach using a copper backing-wheel device was developed to aid the fabrication process of industrial cryogenic storage tanks manufactured under the ASME Section VIII Division 1. This research focused on the welding processes related to the cylindrical-body assembly. Two processing steps involving the root-run formation and the replacement with a sound outer-circumference joint were studied. Initially, tank fabrication is achieved through the application of both flux-cored arc welding and submerged arc welding. A new processing approach was proposed with the modified method in cross-section preparation, and a low-cost reusable copper backing-wheel device was developed to facilitate the root-run formation using only submerged arc welding. Temperature gradient through the device components along the heat-conduction path was monitored to assure the conductivity of the backing device. The results suggest that the proposed approach reduced manufacturing time by removing the initial flux-cored arc welding process used in the conventional welding method. As an effect, the new approach show promise reduces the overall manufacturing cost of tank fabrication. Based on radiographic testing of tanks fabricated using the new approach found that circumference joints required little or no welding repair suggesting higher joint quality.

• Periodical: Applied Mechanics and Materials (Volume 705)
• Pages: 106-111
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.705.106
• Online since: December 2014
• Authors: Supphachan Rajsiri*, Mayuree Chomjanngam, Sittiphun Tuntawiroon
• Keywords: Backing Wheel, Cryogenic Storage Tank, Radiographic Testing, Submerged Arc Welding

References

[1] M. Stewart and O.T. Lewis, Pressure Vessels Field Manual: Common operating problems and practical solutions, Gulf Professional Publishing, Massachusetts, (2012).

[2] S. Rajsiri, K. Penpondee and S. Tuntawiroon: submitted to Advanced Materials Research Journal (2014).

[3] V. Malin: Weld. J. 80 (2001) 227S-237S.

[4] ASTM Standard E94, 2010, Standard guide for radiographic examination, ASTM International, West Conshohocken, PA, 2010, DOI: 10. 1520/E0094-04R10, www. astm. org.

[5] ASTM Standard E1032, 2012, Standard test method for radiographic examination of weldments, ASTM International, West Conshohocken, PA, 2010, DOI: 10. 1520/E1032-12, www. astm. org.

[6] B. Messer, C. Patrick and S. Seitz: Int. J. Pres. Ves. Pip. 83 (2006) 365-372.

[7] R. Li, T. Wang, C. Wang, F. Yan, X. Shao, X. Hu and J. Li: Opt. Laser Technol. 64 (2014) 172-183.

[8] J.H. Casey, U.S. Patent 3, 940, 048. (1976).

[9] N.R. Mandal and R. Maiti: Sci. Technol. Weld. Joi. 10 (2005) 319-324.

[10] K. Umeno, T. Oishi, Y. Kimura, A. Masamura and A. Iwasaki, U.S. Patent 5, 449, 107. (1995).

[11] A. Masamura, Y. Kimura and A. Iwasaki, U.S. Patent 5, 590, 829. (1997).