Cooling Profile Analysis of Hot Strip Coil Using Finite Volume Method

Abstract:

To get the low temperature transformation product of austenite, study of cooling behavior of coil is essential. Temperature distribution profile of the hot strip coil has been determined by using finite volume method (FVM) vis-à-vis finite difference method (FDM). It has been demonstrated that FVM offer greater computational reliability in estimation of contact pressure distribution and hence the temperature distribution for curved and irregular profiles, owing to the flexibility in selection of grid geometry and discrete point position, Moreover, use of finite volume concept allows enforcing the conservation of mass, momentum and energy, leading to enhanced accuracy of prediction.

• Periodical: Applied Mechanics and Materials (Volumes 789-790)
• Pages: 496-502
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.789-790.496
• Online since: September 2015
• Authors: Subhamita Chakraborty, Shubhabrata Datta, Sujay Kumar Mukherjea, Partha Protim Chattopadhyay
• Keywords: Coil Cooling, Contact Pressure, Finite Volume Method, Modeling, Simulation, Thermal Analysis

References

[1] J. Wang, G. Li and A. Xiao: Mater. T. Jim. Vol. 52- 11 (2011), p. (2027).

[2] A. Saboonchi and S. Hassanpour: J. Mater. Process. Tech. Vol. 182-183 (2007), p.101.

[3] A. Saboonchi and S. Hassanpour: Appl. Therm. Eng. Vol. 28-13 (2008), p.1630.

[4] A. Saboonchi, S. Hassanpour and A. Hajiannezhad: J. Therm. Stresses. Vol. 33-36 (2010), p.521.

[5] H.H. Cho, Y.G. Cho, Y.R. Im, J.K. Lee, J.H. Kwak and H.N. Han: J. Mater. Process. Tech. Vol. 210-217 (2010), p.907.

[6] S. J. Park, B.H. Hong, S. C Baik and K. H Oh: ISIJ Int. Vol. 38-11 (1998), p.1262.

[7] J. D Anderson, G. Degrez and R. Grundmann, in : Computational Fluid Dynamics an Introduction, Chapter, 2, Springer, Verlag Berlin Heidelberg (1981).

[8] J. C. Tanehill, D. A. Anderson and R.H. Pletcher, in: Computational Fluid Mechanics and Heat Transfer, Chapter, 3, Taylor & Francis, USA (1997).

[9] J. Slowik, G. Borchardt, C. Kohler, R. Jeschar and R. Scholz: Steel. Res. Vol. 61(1990), p.302.

[10] J. Pullen and J.B.P. Williamson: Proc. Royal society, London, (1972)p.159.

[11] B.B. Mikic: Int. J. Heat. Mass. Tran. Vol. 17- 2 (1974), p.205.

[12] S.C. Baik, O. Kwon, J. Park, B.H. Hong and K.H. Oh: Met Matr. Vol. 5- 4 (1999), p.369.

[13] W. Johnson and P. B. Mellor, in: Engineering Plasticity, chapter 4, Van Nostrand Reinhold Company, London (1973).

[14] M. Bamberger and B. Prinz: Mater. Sci. Tech. Ser. Vol. 2-4 (1986), p.410.