The Technology Research of CO₂ Laser Micropore Drilling on Carbon Steel

Abstract:

. Five kind of carbon steel were chosen to do the test of CO2 laser micropore drilling in the paper, it were obtained that the influence curves of laser power, pulse width, defocusing amount and repetition rate to the upper aperture and the taper of the hole, and the influence of laser parameters and the carbon content to the drilling quality were system analyzed using double factors without repeating test method, the result show that the value of laser power and pulse width has significant influence to the upper aperture, to taper of hole is less. The influence of the repetition rate of laser and defocus amount to the upper aperture was weak, and the influence to the upper aperture was very significant with the change of the value of carbon content and the repetition rate.

• Periodical: Advanced Materials Research (Volumes 139-141)
• Pages: 777-781
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.139-141.777
• Online since: October 2010
• Authors: Dai Min Chen, Zhan Guo Li, Jing Jing Li, Jia Xing Li
• Keywords: Carbon Content, Carbon Steel, CO₂ Laser, Laser Drilling

References

[1] X.D. Li and W. Wang: Aeronautical Engineering and Maintenance, (2000) No4, pp.44-45 (In Chinese).

[2] F.S. Liu, H.B. Xu, and S.K. Gong: Acta Aeronautica Et Astronautica Sinica, Vol. 24 (2003) No. 2, pp.178-182(In Chinese).

[3] L.S. Song, G.Q. Shi, and Z.G. Li: Tool Technology, Vol. 40 (2006) No. 8, pp.12-15(In Chinese).

[4] W.Y. Duo, M.C. Wang and S.B. Zhang: Laser journal, Vol. 24 (2003) No. 4, pp.1-3(In Chinese).

[5] D. Guo, L.S. Li, K. Cai and Z.L. Gui: Electronic Components and Materials, Vol. 22 (2003) No. 3, pp.46-48(In Chinese).

[6] Q.G. Zheng: The advanced manufacture technology of laser (The Press of Huazhong University of Science and Technology, Chinese 2004).

[7] C.L. Ma: The method and application of the modern design optimization of modern experiment (The Press of Zhengzhou University, Chinese 2007).