Research on Leveling Model of Combination Leveler

Abstract:

The evolvement of plate in 15-roller combination leveler has been studied in this paper using both geometrical analysis and FEM. The results show that the bending deformation and curvature evolvement are different from those obtained by general leveler. The technologies of parallel leveling and tension leveling are adaptive to the roll system of combination leveler, which not only can improve leveling precision, but also can erase the influence of negative torque on leveling roll, thus improving the leveling strength capacity of leveling materials. Meanwhile, a new calculating method of leveling process was pointed out, whose results were basically consistent to those of experimental results.

• Periodical: Advanced Materials Research (Volume 145)
• Pages: 453-457
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.145.453
• Online since: October 2010
• Authors: Xiao Gang Wang, Qing Xue Huang, Jian Mei Wang
• Keywords: Combination, Leveling Model, Medium Plate Steel, Thick Plate Steel

References

[1] Chenying. The development of medium & thick plate leveling technology. Medium & thick plate, Vol, 8(2002), No 6, p.5(in Chinese).

[2] Yuanguo, Huang qingxue. The development and prospect of medium & thick plate leveling technology, Journal of Taiyuan Heavy Machinery Institute, Vol, 1(2002), No 4, p.40 (in Chinese).

[3] Wang Guodun, Liu Xianghua, Wang Jun. The development of national medium & thick plate technology, Rolling machinery, Vol, 21(2004), No 6, p.5 (in Chinese).

[4] Yang guchuan. The structure of variable gap leveler for medium & thick plate and its home and aboard status, metallurgy device, Vol, 1(2002), No 6, p.33 (in Chinese).

[5] Wang Guodun, Liu Xianghua. The development and status of Japanese medium & thick plate technology(Second), Rolling machinery, Vol, 24(2007), No 3, p.1 (in Chinese).

[6] Li Qiang, Yan Hongbo, Go jianyu. Discussion the feasibility of erasing negative torque on parallel leveler by varying roll speed. Baotou Steel Institute, Vol, 25(2006), No 1, p.74 (in Chinese).