Simulation of the High-Speed Milling Temperature of Titanium Alloy Ti - 6Al - 4V

Xin Chun Huang; Chang Feng Yao; Ding Hua Zhang; Jun Xue Ren

doi:10.4028/www.scientific.net/AMR.314-316.1171

Paper Titles

Constitutive Equation for V–5Cr–5Ti at High Temperatures Measured Using the SHPB Technique
p.1154

Influence of δ Phase Content on Hot Deformation Behavior of Ni-Based Superalloy IN718
p.1159

Effect of Welding Thermal Cycle on the Microstructure and Mechanical Properties in Multi-Pass Submerged-Arc Welding
p.1163

Experimental Study on Ball End Mill in Glass Machining at High Speed
p.1167

Simulation of the High-Speed Milling Temperature of Titanium Alloy Ti - 6Al - 4V
p.1171

Analysis and Experimental Research on Chemical Mechanical Polishing Flow Field
p.1176

Microstructure and Mechanical Property of GH4169 Joints by Vacuum Diffusion Bonding
p.1180

Microstructure and Mechanical Property of the ZrB₂-Based Ultra-High-Temperature Ceramic Composites Brazed Joint
p.1184

New Chip Flow Angle Prediction to Investigate the Effects of Ratio of the Cutting Edge Lengths on Chip Flow Using Sharp Corner Tools
p.1189

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 314-316Simulation of the High-Speed Milling Temperature...

Simulation of the High-Speed Milling Temperature of Titanium Alloy Ti - 6Al - 4V

Abstract:

To study of the temperature generating mechanism of Titanium Alloy Ti - 6Al - 4V in high speed, and the influence rule of the milling process parameters for milling temperatures, A temperature simulation model of the milling process was found with AdvantEdge, the relationship between the high speed milling parameters and the milling temperature of Titanium Alloy Ti - 6Al - 4V was discussed by the finite element simulation, and the milling process temperature was measured by the half artificially thermocouple methods. The result show that the highest temperature are reached at close to the tool tip in the rack face, the feed per tooth have significant effect on the milling temperature, while cutting depth and milling width have little effect. The milling temperature increase with the feed per tooth increasing，the highest temperature increase with the spindle speed increasing.