Analysis of the Anti-Bird Impact Performance of Typical Beam-Edge Structure Based on ANSYS/LS-DYNA

Yong Kang Zhang; Yu Long Li

doi:10.4028/www.scientific.net/AMR.33-37.395

Paper Titles

Hierarchical Adaptive Mesh for FEM Simulations of Ultra High-Speed Impact Problem
p.369

Finite Geometrically Similar Element Method for Dynamic Problem of a Cracked Specimen
p.375

Evaluation and Characterization of Plastics-Made Sheet Type Components under Impact
p.381

Behavior of Thin-Walled Square Tube and Tubular Hat Sections Subjected to Low Velocity Impact Loading
p.387

Analysis of the Anti-Bird Impact Performance of Typical Beam-Edge Structure Based on ANSYS/LS-DYNA
p.395

Study of Initiator’s Shock-Resistibility Through Impact Using Hopkinson Pressure Bar
p.401

A Study of Creep Properties of Polymer Bonded Explosives
p.407

Analysis of Finite Element Viscoelastic Displacement Based on Kelvin Model
p.413

Experimental and Numerical Study of Cyclic Creep of Cast Magnesium Alloy at High Temperature
p.421

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 33-37Analysis of the Anti-Bird Impact Performance of...

Analysis of the Anti-Bird Impact Performance of Typical Beam-Edge Structure Based on ANSYS/LS-DYNA

Abstract:

The 3-D finite element analysis model of beam-edge structure with spaced multiple layers under bird impact is established. Numerical simulations are implemented by using the non-linear contact-impact code ANSYS/LS-DYNA when the birds collide at three locations of the structure respectively. The failure process of the structure and the equivalent plastic strain at supports are obtained. The residual strength of the structure after impact is predicted. The results show that the front spars are penetrated or cracked after the leading edge is perforated. The equivalent plastic strain at the support is much higher when the bird impacts the structure at the central location. Both the structure deformation and failure mode from the simulation are consistent with the results of full scale test, which proves the validity of the method proposed in this paper.