Proportion Design of Autoclaved Cement Concrete Based on High Strength

Tie Quan Ni; Chang Jun Ke; Li Zhang

doi:10.4028/www.scientific.net/AMR.391-392.161

Paper Titles

Effect of Different Compatibilizing Agents on the Compatibility of Lignin/LDPE Composites
p.143

Properties Analysis of Organic Montmorillonite (OMMT) Reinforced RTV Composites
p.147

Influences of Rare-Earth Ions Doping on the Structure and Photocatalytic Activity of TiO₂
p.151

Research on the Interfacial Tension between Anion Gemini Surfactant Solution and Crude Oil
p.156

Proportion Design of Autoclaved Cement Concrete Based on High Strength
p.161

Study on the Resistance Spot Microwelding Parameters of Copper and Nickel-Plated Steel Dissimilar Metals
p.165

Excess Gibbs Free Energies of Selected Binary Halogenated Silane Mixtures at 101.3KPa
p.170

Single Layer Graphene Oxide Sheets-Epoxy Nanocomposites with Greatly Improved Mechanical and Thermal Properties
p.175

Preparation of High-Performance Brick from Construction and Demolition Waste
p.180

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 391-392Proportion Design of Autoclaved Cement Concrete...

Proportion Design of Autoclaved Cement Concrete Based on High Strength

Abstract:

According to the particularity of the autoclaved cement concrete that partial aggregate could participate in hydration reaction in the process of autoclaving, the optimal gradation of coarse aggregate and the optimal slurry aggregate ratio is studied, and the effect of water reducing agent for fluidity of cement paste is also studied. The optimized mix design of autoclaved cement concrete based on high strength (compressive strength and flexural strength) is done by orthogonal test with four factors (water-binder ratio, type of mineral admixture, amount and sand ratio) and four levels.