Effect of Low-Voltage Electric Current Pulse on Semi-Solid Microstructure of Magnesium Alloy AZ91D

Abstract:

The effect of discharging cycle, voltage, capacitance and time on solidified microstructure of semi-solid slurry of AZ91D alloy treated with Low-Voltage Electric Current Pulse(LVECP) was investigated in this paper. The experimental results show that primary grains of AZ91D alloy were refined apparently, the morphology dendrites of α-Mg were changed by electric current pulse and the nondendritic structure of semi-solid slurry of AZ91D alloy could be obtained with appropriate processing parameters. The decrease of discharging cycle and the increase of discharging voltage and time to prepare semisolid slurry by LVECP discharge promotes the formation of fine α-Mg grains. It is proposed that LVECP treatment created a new dynamic factor for nucleation so that the number of nuclei increased, which restrained the formation of large primary α-Mg dendrites and created a base to form spherical crystals of primary α-Mg. The stronger temperature fluctuation in the melt with many rosette primary α-Mg caused by LVECP discharge and the remelting of the secondary arm roots in the same time are the most important reasons for formation of spherical primary α-Mg grains.

• Periodical: Advanced Materials Research (Volumes 399-401)
• Pages: 1613-1619
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.399-401.1613
• Online since: November 2011
• Authors: Quan Zhou, Le Ping Chen, Jian Yin
• Keywords: Low-Voltage Electric Current Pulse, Magnesium Alloy, Semi-Solid Microstructure

References

[1] R.F. Deker: Adv. Mater. Process Vol. 154 (1998), pp.31-33

[2] B.L. Mordike and I. Ebert: Mater. Sci. Eng. Vol.A 302 (2001), pp.37-45.

[3] M.Nakada and M.C. Flemings: ISIJ International Vol.30 (1990), pp.27-33

[4] J.M.Li and H.Lin: Scripta Metallurgica et Materialia Vol.31 (1994 ), pp.1691-1694

[5] J.P. Barnak, A.F. Sprecher and H.Conrad: Scripta Metallurgica et Material Vol.32 (1995), pp.879-884

DOI: 10.1016/0956-716x(95)93218-s

[6] H.C. Yan, G.H.He and B.L. Zhou: Acta Metallurgica Sinica Vol.33 (1997), p.352(In Chinese)

[7] S.X.He, J.Wang and B.D. Sun: The Chinese Journal of Nonferrous Metals Vol.12 (2002), pp.425-428

[8] Y.Tang, J.Z. Wang and D.Q. Cang: J.Univ.Sci.Tech.Beijing Vol.6 (1999), pp.94-96

[9] M. Gao, G.H. He and F. Yang: Mater. Sci. Eng. A Vol.337 (2002), pp.110-114

[10] S.Akiyama, I.Ueno, and M.Sakamoto: Mater. Res. Jpn Vol.39 (2000), p.72

[11] Q.Z.Le, P.Ou and Y.D.Wu: Acta Metallurgica Sinica Vol.38 (2002), p.220

[12] Y. Dolinsky and T. Elperin: Phys. Rev. Vol.47B (1993), p.14778

[13] M.C. Flemings: Metall. Trans. Vol.22A (1991), pp.957-981