A Novel Intelligent Application of Arduino Processor in Automated Vehicle Speed Control System

Abstract:

The prime reason for the accidents in the school zone is due to over speeding of the vehicles. The objective of the project is to design and implement a device that controls the speed of the vehicle in required areas. This is to be achieved using the Arduino processor board that is attached in the vehicle. The device consists of two main components, the transmitter and the receiver. The transmitter gets activated during the peak hours and sends the Radiofrequency .The receiver that is attached to the vehicle senses the Radio frequency. This enables the fuel control mechanism by automatically controlling the butterfly valve that is responsible for the amount of fuel pumped into the engine. Simultaneously the countdown timer starts. The speed is maintained till the timer reads zero, after that the vehicle resumes its original state.

• Periodical: Advanced Materials Research (Volumes 403-408)
• Pages: 5088-5091
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.403-408.5088
• Online since: November 2011
• Authors: S.Kaja Mohideen, M.Mohamed Sadiq, G.V. Ashwini, P. Ajay

References

[1] Fahad, Ahmed, Bhawani S. Chowdhry, electronic gear shifting system for motorcycle, Springer, November 14, (2008).

[2] http: /www. mouthshut. com/review/Automatic_Gear_Vs. _Manual_Gear-30865-1. html.

[3] HSIEH H. -I. (1), TSAI L. -W. (1) , The selection of a most efficient clutching sequence associated with automatic transmission mechanisms, Journal of mechanical design   , 998, vol. 120, no4, pp.514-519.

DOI: 10.1115/1.2829308

[4] S. Prabhu An Embedded semi-Automatic gear transmission system, ICMEE 09 IACSIT.

[5] www. dickifield. sydneywellbeing. com/motorcycles. html.

[6] Kerrod, Robin. How•It•Works: Motorcycles. New York: Gloucester Press, (1989).

[7] Daryl Gerke and William kimmel, EMI and Circuit Components, EDN, September 1, (2000).

[8] Designing for EMC (workshop), Kimmel Gerke Associates, Ltd., (1994).