Fabrication of Porous Structured SnO₂/In₂O₃ Composite by Solid-Phase Reactive Sintering

Abstract:

This paper studied affect of porous structure SnO₂/In₂O₃composites about sinter temperature and chemical content of SnO₂ by solid-phase reactive sintering method. It studied on the influence of different content of SnO₂ and sintering temperature to porous structure SnO₂/ In₂O₃ composites. The microstructure and phase were analyzed by SEM (Scanning Electron Microcopy) and XRD (X-ray diffraction). The results showed SnO₂/In₂O₃ composites had better porous structure as following conditions: the content was 10% SnO₂ in SnO₂/In₂O₃ composites and sintering temperature was 1300°C holding 3 hours after 600°C holding 1 hour, and then cooling to room temperature in the furnace.

• Periodical: Advanced Materials Research (Volume 412)
• Pages: 53-56
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.412.53
• Online since: November 2011
• Authors: Xiao Long Zhou, Jian Chun Cao, Jin Hu, Yuan Yuan Peng, Jie Yu, Yu Cao, Jing Chao Chen
• Keywords: Porous Structure, SnO₂/In₂O₃ Composite, Solid-Phase Sintering

References

[1] C.M. Ghimbeu, J. Schoonman, et al.: Ceramics International Vol. 34 (2008), p.95.

[2] J.H. Smatt, N. Schuwer, et al.: Mesopor(2007). Mater. doi: 10. 1016/j. micromeso. 2007. 10. 003.

[3] K.D. Benkstein, S. Semancik: Sensors and Actuators B. Vol. 113 (2006), p.445.

[4] T. Hyodo, K. Sasahara, et al.: Sensors and Actuators B . Vol. 106 (2005), p.580.

[5] L.G. Teoh, M.H. Hon, et al.: Sensors and Actuators B. Vol. 96 (2003), p.219.

[6] Y.D. Wang, X.H. Wu, et al.: Solid-State Electronics. Vol. 48 (2004), p.627.

[7] Y. Shimizu, T. Hyodo, et al.: J. Europ. Ceram. Soc. Vol. 24 (2004), p.1389.