Dissimilar Friction Stir Welds in AA 5086-AA 2024: The Effect of Process Parameters on Microstructures and Mechanical Properties

Abstract:

The effect of tool traverse and rotation speeds on the microstructures and mechanical properties are quantified for welds between non-age-hardening Al5083 and age hardening Al2024 and compared to single alloy joints made from each of the two constituents. In this paper, we report the results of microstructural, mechanical property investigations of Al5186Al2024 friction stir welds produced using various rotations and traveling speeds of the tool to investigate the effects of the welding parameters on the joint strength. Metallographic studies by optical microscopy, electron probe microscopy, and the utilization of the X-ray diffraction technique have been conducted. It was found that the weld properties were dominated by the thermal input rather than the mechanical deformation by the tool. In particular the larger stresses under the weld tool on the AA5186 side compared to the AA2024 side are related to a transient reduction in yield stress due to dissolution of the hardening precipitates during welding prior to natural aging after welding.

• Periodical: Advanced Materials Research (Volume 445)
• Pages: 753-758
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.445.753
• Online since: January 2012
• Authors: Seyed Ali Asghar Akbari Mousavi, S.H. Sham Abadi
• Keywords: Age Hardening, Friction Stir Welding (FSW), Microstructure, Scanning Electron Microscope (SEM), X-Ray Diffraction (XRD)

References

[1] J. K. Wessel: Handbook of Advanced Material (John Wiley and Sons), Inc., Hoboken, New Jersey (2004).

[2] S. Preetish, S. Muthukumaran and S.K. Mukherjee: India J. Mat. Proc. Techn. Vol. 197 (2008), p.17–21.

[3] S. Yutaka, S. Hwan, C. Park M. Michiuchi and K. Hiroyuki: Scrip. Mat. Vol. 50 (2004), p.1233–1236.

[4] R.S. Mishra and Z.Y. Mab: J. Mat. Sci. & Eng. Vol. R 50 (2005), p.1–78.

[5] M. Jacques: Corrosion of aluminum, Alcan Engineered Products, First edition (2004).

[6] C. Leitao, R.M. Leal, D.M. Rodrigues, A. Loureiro and P. Vilac: J. Mat. & Des. Vol. 30 (2009), p.101–108.

[7] A. Simar. Universite Catholique De Louvain (2006).

[8] S.T. Amancio, S. Sheikhia, J.F. Santosa and C. Bolfarini: J. Mat. Proc. Techn. Vol. 206 (2008), pp.132-142.