The Design of Control System of Camshaft Grinding Machine Based on FANUC 0i-TC

Ai Hua Ren; Chuan Qiong Sun

doi:10.4028/www.scientific.net/AMR.468-471.1136

Paper Titles

Effect of Heat Treatment on Decay Resistance of Chinese Fir and Pine
p.1118

Vibration Performance Optimization of the Semi-Active Suspension with Fuzzy Control Method
p.1123

Development of a Practical Scanning Acoustic Microscopy
p.1128

The Double-Bridge Beam Structure with Slots for Microaccelerometer
p.1132

The Design of Control System of Camshaft Grinding Machine Based on FANUC 0i-TC
p.1136

Sliding Mode Control of Electronic Throttle Valve Based on Rapid Control Prototyping
p.1141

Research on Rapid Detection Technology for Irregular Surface Products
p.1148

Simulation and Optimization of Power Train System of Light-Duty Passager Car Based on CRUISE
p.1152

Two-Sensor Information Fusion with Out-of-Sequence Measurement
p.1158

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 468-471The Design of Control System of Camshaft Grinding...

The Design of Control System of Camshaft Grinding Machine Based on FANUC 0i-TC

Abstract:

Grinding machine is widely used in the camshaft producing process. H187 slanting headstock camshaft grinding machine is upgraded from the original relay, contactor and other electronic controlled system into PMC controlled CNC machine tool by using FANUC 0i-TC system, which is not only to adapt to the current auto industry production mode of “more batches and more variety”, but also to improve the production efficiency and the manufacturing quality. The upgrading process is introduced especially from the following aspects such as the design of CNC system architecture and electrical control system, development of grinding feed NC program and PMC program. It is proved that this transformation fully realized the expected goals from practice.