Research on Microcomputer Control System for Spherical Surface Grinder of Engine Valve Tappet

Jian Jun Hao; Chang Cheng; Zhi Gang Zhang; Shuai Shuai Ge

doi:10.4028/www.scientific.net/AMR.468-471.3102

Paper Titles

The Exploratory Study and Research in Network Environment
p.3081

Research on Forecasting the Research Costs of Applying Cost-Time Cumulative Curve to the Military Container Roll In/Out Platform
p.3085

Research on Information Technology and Equipment for Vegetable Quality Safety Supervision
p.3089

Research on International Standards of Gas and Material Compatibility in Cryogenic Vessels
p.3096

Research on Microcomputer Control System for Spherical Surface Grinder of Engine Valve Tappet
p.3102

Research on Loss and Temperature Rise of a Novel Dynamic Electromagnetic Induction Heater
p.3108

Study and Selection of Working Fluids for Organic Rankine Cycle (ORC) Using Engine Waste Heat Energy
p.3113

Stresses of Existing Pavement Induced by Widened Embankment over Soft Soils
p.3117

The Calibration System of Gas Flow Meter Based on Standard Flow Meter Method
p.3122

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 468-471Research on Microcomputer Control System for...

Research on Microcomputer Control System for Spherical Surface Grinder of Engine Valve Tappet

Abstract:

We propose a new control scheme based on analyzing the problems existed in the original machine tool. We use single chip Microcomputer as controller, stepper motor to drive machine table, and power monitor for grinding contact detecting. The principle of grinding contact detection was elaborated, the structure of computer hardware and software are presented. The developed control system has been used for machine. The results show that the control system runs properly and achieves the desired effect.