Study on Semi-Solid Magnesium Alloy Fabricated by Ultrasonic Stirring Method

Hong Yan; Zhi Hu; Zeng Pan

doi:10.4028/www.scientific.net/AMR.47-50.347

Paper Titles

Oxide Films Produced on Fe₁₉Cr₅Al Steel Coated with Al, Pt and Al+Pt Composite Nanofilms: Technological Aspects and Catalytic Properties
p.331

Catalytic Destruction and Removal of Toluene by Microwave/Fe₃O₄ System
p.335

Using Catalyst and Electrolysis Diaphragm Method to Produce Multiple Oxidants to Remove the Scaling and Slime in Cooling System
p.339

Bio-Chemical Sensor Based on Smart Material
p.343

Study on Semi-Solid Magnesium Alloy Fabricated by Ultrasonic Stirring Method
p.347

Optimization of Preparation of the TiO₂ Photocatalytic Reactor Using the Taguchi Method
p.351

Synthesis and Characterization of Bamboo-Like Carbon Nanotubes
p.355

Preparation of Silica Nano-Rods by CVD
p.359

Synthesis of Mono-Sized Silica Nanoparticles by Combustion Technique
p.363

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 47-50Study on Semi-Solid Magnesium Alloy Fabricated by...

Study on Semi-Solid Magnesium Alloy Fabricated by Ultrasonic Stirring Method

Abstract:

The perfect semi-solid magnesium alloy had been prepared using ultrasonic stirring method. The effect of technological parameters such as melt temperature, ultrasonic power and ultrasonic treatment time on the microstructure of semi-solid AZ61 alloy had been investigated. The results showed that the better refined and well-distributed globular semi-solid magnesium alloy had been acquired with the increasing of output power of ultrasonic stirring when melt temperature and ultrasonic treatment time were at a certain range.