Optimal Design of Small Winching Drum Installed in Skidding Tractor Based on Computer Aided Design

Pei Jian Zhang; Ming Xu Pan; Li Hai Wang

doi:10.4028/www.scientific.net/AMR.487.277

Paper Titles

Single-Phase Sine Inverter Power Supply Based on PIC18F2431
p.258

Simplified Simulation and Compute of the Horizontal Displacement of Diaphragm Wall
p.263

The Design, Manufacture and Wind Tunnel Test of the Full Aircraft Transonic Flutter Model
p.267

Preparation of the Photocatalyst Textiles and Test on the Antibacterial Properties
p.273

Optimal Design of Small Winching Drum Installed in Skidding Tractor Based on Computer Aided Design
p.277

Design and Implementation of the Parametric Designing System Based on ADO
p.281

The Brief Introduction of the Conditions for Extreme Range in the Motion of Oblique and up Throwing
p.285

A Manipulator Terminal Actuator Controlled by Microcomputer
p.289

P2P Traffic Identification Algorithm Based on Topology
p.297

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 487Optimal Design of Small Winching Drum Installed in...

Optimal Design of Small Winching Drum Installed in Skidding Tractor Based on Computer Aided Design

Abstract:

Computer aided design was adopted into the design process of winching drum in this paper. First, mathematical modeling was conducted to the design based on traditional means. Then the parameters of the winching drum were optimized by MATLAB. And the smallest drum was obtained under the condition of same length winching rope. In order to check the optimal design result of the strength of the drum in the bad operation environment, finite element analysis method was adopted, which simulated and verified the reliability of the winching drum.