A New Kind of Locking Device for Centrifuge Nacelle

Qian Liu; Zhi Gang Deng; Xin Xiong

doi:10.4028/www.scientific.net/AMR.490-495.29

Paper Titles

A Limited Interval Gradient Projection Algorithm for Inverse Kinematics
p.7

A New Hardware-in-the-Loop Test System for Electronic Control Unit of Dual-Clutch Transmission Vehicle
p.13

A Clonal Selection Algorithm Based Optimization of Activated Sludge Process
p.19

A Method for Path Generation of Robot Automatic Polishing Based on Bounding Box
p.24

A New Kind of Locking Device for Centrifuge Nacelle
p.29

A Temperature Control Method about Two-Dimensional Correlation of Infrared
p.33

A Multi-Channel Data Acquisition System and its Performance Analysis Method Based on FPGA
p.37

Design of PCB Engraving Machine System Based on MCU
p.42

A New Chaos Analysis Method: Exclusion Analysis Method and its Application: Simulation and Comparison
p.46

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 490-495A New Kind of Locking Device for Centrifuge...

A New Kind of Locking Device for Centrifuge Nacelle

Abstract:

In this paper, a new kind of locking device is introduced. Aiming at the 1# centrifuge of CAEP(China Academy of Engineering Physics), the mechanical design of locking device has been done, and its maximum locking torque is 8000N•M. The simulation model has been established in ANSYS to obtain key parameters of the locking device, such as the thickness of shaft, the distribution of circular groove, the working pressure of oil source and so on. Through the test, the feasibility of the locking device is validated.