Study on Fatigue Crack Behavior in Welded Structure of DSS 2205

Abstract:

The fatigue crack growth behavior of weld metal (WM), heat affected zone (HAZ) and base metal(BM) of Duplex Stainless Steel (DSS) 2205 standard sample was tested in different stress ratios at HF fatigue testing machine. ANSYS analysis software was used to simulate the fatigue crack growth rate of the steel under different stress ratio. Regression equations and da / dK-ΔK curves of experiment and simulation are compared and analyzed. The results show that the fatigue crack growth rate of WM is slowest and the ability to resist fatigue crack growth is highest among the three parts, the lowest is BM. Secondly, the sensitivity of the rate caused by the stress change of WM is the highest, and the lowest is BM. The simulation of fatigue crack growth rate of DSS 2205 is completely correct and feasible by the experiment.

• Periodical: Advanced Materials Research (Volumes 503-504)
• Pages: 991-994
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.503-504.991
• Online since: April 2012
• Authors: Zhi Xiang Wang, Zheng Lun Wang, Xin Zhang
• Keywords: Duplex Stainless Steel, Fatigue Crack Growth Behavior, Finite Element, Welded Structure

References

[1] Zhigang Liu: Ship & Ocean Engineering, Vol. 1, 2002, pp.19-20. in Chinese.

[2] Huaren Yang: Theory of welded structure fatigue strength. (Northeastern University Press, Shenyang, 2002), in Chinese.

[3] Internet on http: /202. 114. 9. 17/hjwx/w007961. pdf.

[4] GB6398-2000. National Bureau of Standards, 2000, in Chinese.

[5] Sieurin Henrik, Sandstrom Rolf: Materials Science and Engineering， (2006), pp.250-256.

[6] Yihui Zhou: Earthquake Engineering and Engineering Vibration, Vol. 3 (2010), pp.449-457, in Chinese.