Optimization Design of Stack Package Warpage Based on Moldflow Software

Abstract:

Currently, 3D multi-chip stack assembly is becoming the future development direction of advanced manufacturing process for printed circuit board. However, during the process of Components stacked packages, Warpage control of chips in the reflow soldering is particularly important. By Combining Taguchi method and injection molding simulation software – Moldflow, this paper studied FBGA and PBGA warpage deformation in the POP, setted four design factors, such as the mold temperature, melt temperature, injection pressure and injection time , find out the minimum warpage combination of design and critical design factors affecting the warpage. Then the factors are ranked according to the degree of the impact of the above experiments. The best combination of levels for these factors is getted, the stacked package parameter is optimized. Experiments show that the value of warpage decreased significantly.

• Periodical: Advanced Materials Research (Volumes 605-607)
• Pages: 34-37
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.605-607.34
• Online since: December 2012
• Authors: Ming Xiang Zang, Ting Wang, Chen Liu, Yong Rui Zhao
• Keywords: Moldflow Software, Orthogonal Design, Taguchi, Warpage Optimization

References

[1] Xu Danwen,Sun Jian,Jiang Jianguo,ZangMingxiang,He Huisen,Study of Stacked Packaging Technology for Advanced PCB Manufacturing Process.Value Engineering.2010,29(34)

[2] Yan Xueyou,Li Guoyuan, Optimize the PoP warpage based on the Taguchi experimental design. Journal of GuiLin university of electronic technology.2009,10.

[3] XIE B,SUN P,SHI X Q.Design advisor for package-on-package(POP) manufacturing[C]// International Conference on Electronic Package Technology & High Density Packaging,2008:1-7.

DOI: 10.1109/icept.2008.4606950

[4] Wu Zhenfan,Sun Baoshou,Chen Zhe, Injection molding warpage optimization and its influencing factors based on Moldflow. Light Industry Machinery, No. 27, 2009,12.

[5] Wu Zhenfan,Sun Baoshou,Zhang Yong, Injection molding warpage optimization based on Taguchi experimental design.Journal of NingBo University(NSES), Vol 24 No.3.

[6] Lu Xuehong, Khim L S.A statistical experimental study of the injection molding of optical lenses[J].Materials Processing Technology,2001,113:189-195.

DOI: 10.1016/s0924-0136(01)00606-9

[7] Jiang Zhanglei,Sun Wenlei, Injection molding Warpage simulation analysis based on the orthogonal experiment.No 12,2010,12.

[8] Wang Lixia, The injection molding process optimization and product quality control based on numerical simulation[D]. Zhengzhou University,2004.

[9] Li Yunyan, Hu Chuanhong, Experimental Design and Process. Chemical Industry Press,2005:235.