Measurement and Verification of Injection Molding Machine Energy-Saving Reformation Effect

Abstract:

The energy-saving effect of the injection molding machine energy-saving reformation project was measured in a factory. Based on the analysis of the project energy-saving principle, analyzed the energy-saving rate of the reformed injection molding machine in case of producing different products. The test results show that the active power saving rate is 50% under the load condition, the active power saving rate is more than 75% under the no-load condition and energy-saving effect is more obvious under the no-load condition. Finally, analyzed the power quality impact caused by the energy-saving equipment on the distribution network, put forward some suggestions for improvement.

• Periodical: Advanced Materials Research (Volumes 608-609)
• Pages: 1139-1142
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.608-609.1139
• Online since: December 2012
• Authors: He Wang*, Xue Fei Zhang, Rui Ming Tong, Tao Yong Li, Meng Jie Shi
• Keywords: Energy-Saving Rate, Injection Molding Machine, Measurement and Verification, Power Quality (PQ)

References

[1] Hanru Zhong, in: The Injection Molding Machine Control system, Chemical Industry Publishers, Beijing (2004).

[2] Yonggang Peng: Energy-saving and Environmental Protection Control System Design of Injection Molding Machine, Zhejiang University (2004).

[3] Fangping Huang, Bing Xu, Huayong Yang: Hydraulics Pneumatics & seals, 3 (2004), pp.22-25