Influence of Temperature Difference on Front End Bending in Hot Slab Rolling

Y X Tan; R. B. Mei; W J Wang; Y Q Liu; Z Liu; L F Huo; C S Li

doi:10.4028/www.scientific.net/AMR.652-654.1952

Paper Titles

Comparative Study on Compression Deformation Behaviors of Cast and Extruded AZ31 Alloys
p.1932

Dynamic Strain Aging during Tensile Deformation of Extruded AZ81 Magnesium Alloy
p.1937

Die Wear Analysis of Spur-Gear Shaft Hot Extrusion Process
p.1942

Forging Effect of Horizontal V - Shaped Anvil for Heavy Axial Forgings
p.1948

Influence of Temperature Difference on Front End Bending in Hot Slab Rolling
p.1952

Development of Cyclic Rotating Bending Process for Microstructure Control of AZ31 Magnesium Alloy Tube
p.1956

FEM Analysis of Glass Lens Molding Press
p.1961

Research on Finite Element Simulation and Test of Two-Pass Deep Drawing Forming for Conical Parts
p.1966

A Study on Initial Blank Design to Minimize Earing in Multi-Stage Deep Drawing Process for Rectangular Cup Using High Strength Steel Material
p.1971

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 652-654Influence of Temperature Difference on Front End...

Influence of Temperature Difference on Front End Bending in Hot Slab Rolling

Abstract:

Front end bending often occurs in the heavy plate mills and roughing stands, which reduce productivity efficiency and the quality of the plates considerably. The effect of temperature difference between top and bottom surfaces of slab and reduction ratio on front end bending was investigated by 3D FEM and the mathematical model was induced. The hexahedral mesh was generated by HyperMesh and embed into the DEFORM system. The results show that the temperature difference leads to the asymmetric distribution of equivalent stress, strain and strain rate in the deformation zone. With the increment of temperature difference and reduction ratio the slab head bends more significant. Additionally, the slab front end perhaps bends to higher temperature side in double phase rolling because of resistance of deformation with different phase. Reducing temperature difference, reducing reduction ratio and avoiding double phase rolling is benificial to reduce front end bending in hot slab rolling.