Small Module Involute Spline Processing with Position Requirements

Abstract:

Spline shaft is widely used as one of the important parts in machinery. Cold rolling process is currently the main processing method to small module splines.For the spline with position requirements, that is: one of the spline tooth is located at an angle of the spline shaft cross section, cold rolling processing can't guarantee the spline tooth position. The paper analyzes the defects existed in the rolling and processing of this kind of spline. Through transforming a hydraulic press and design special frock clamp to ensure the spline tooth position angle, the small modulus involute spline processing with position requirements is realized in the way of punch press processing.

• Periodical: Advanced Materials Research (Volumes 690-693)
• Pages: 2383-2386
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.690-693.2383
• Online since: May 2013
• Authors: Bao Guo Zhang
• Keywords: Cold Rolling Process, Hydraulic Press, Position Angle, Small Modulus Involute Spline

References

[1] ZHENG Quan-gang. Forming technology of straight pillared cold rolling tools for small module involute spline shafts[J]. Automobile Technology & material, 1997(9):16-18.

[2] PAN Zhi-qiang. Small Modulus Involute spline cold rolling technology[J]. Mechanical workers, 2003(12): 43-46.

[3] WU Xiu-yi. Small Modulus Involute spline cold rolling technology[J]. Machinery Manufacturing, 1998(1):16-18.

[4] LIU Zhi-qi, SONG-Jianli, LI Yong-tang,et al . Analysis and Experimental Study on the Precision Cold Rolling Process of Involute Spline[J]. Journal of Mechanical Engineering, 2011(14) :32-38.

DOI: 10.3901/jme.2011.14.032

[5] FENG Yan-fang, Involute spline processing improvement[J]. Ezhou Vocational University, 2009(2):24-26.

[6] JING liang. Designing and manufacturing of the roller for little modulus involuted spline[J]. Metal Forming Technology, 2002(2).50-53.

[7] CUI Feng-kui, LI Yan, LI Chun-mei. The fabricating methods of cold rolling for involute spline shafts[J].Mining & Processing Equipment, 2007, 35(2)：116-119.

[8] WU Xiuyi. The design features of cold rolling geers forsmall module involute spline shafts[J]. Mechanical Engineer, 1997(1)：15-16.

[9] MASTUNAGA R, TAKEMASU T, OZAKI T, et al. Spline rolling of deep drawn cups[C]//Advanced Technology of Plasticity, Proceeding of the 6th ICTP, Sept. 19-24, 1999：2431-2436.

[10] AMIR A, KAMOUNEH, JUN Nia, et al. Investigation of work hardening of flat-rolled helical-involute gears through grain-flow analysis, FE-modeling, and strain signature[J]. International Journal of Machine Tools & Manufacture, 2007, 47：1285-1291.

DOI: 10.1016/j.ijmachtools.2006.08.014