An Experimental Study of Cutting Forces in Ball-End Milling of AISI H13

Tong Chao Ding

doi:10.4028/www.scientific.net/AMR.690-693.2403

Paper Titles

Numerical Simulation of Stress-Strain of AZ31 Mg Alloy Profile during Warm Tension-Rotation Bending Process
p.2379

Small Module Involute Spline Processing with Position Requirements
p.2383

Research on Key Processing Technology of Nuclear Power Tapered Cylinder Forging
p.2387

A Theoretical Model of Grinding Force and its Simulation
p.2395

An Experimental Study of Cutting Forces in Ball-End Milling of AISI H13
p.2403

Analysis on Milling Stability Performed under the Conditions of Positive and Negative Process Stiffness
p.2408

Chip Formation Simulation in FE Modeling for Machining FRP Composite
p.2422

Cutting Force Modeling and Prediction in End Milling Including Flank Wear
p.2427

Effect of Microstructure on Cutting Force and Chip Formation during Machining of Ti-6Al-4V Alloy
p.2437

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 690-693An Experimental Study of Cutting Forces in...

An Experimental Study of Cutting Forces in Ball-End Milling of AISI H13

Abstract:

In the present study, an attempt has been made to experimentally investigate the effects of the cutting parameters on cutting forces in hard milling of AISI H13 steel with coated carbide tools. Designed based on Taguchi method, four factor (cutting speed, feed, radial depth of cut and axial depth of cut) four level orthogonal experiments were conducted. Three components of cutting forces were measured during hard milling experiments and then variance analysis was performed. Finally, the linear regression model was established.