Electrochemical Deburring of Miniature Holes

Xing Hua Zheng; Ze Fei Wei; Zi Yuan Yu

doi:10.4028/www.scientific.net/AMR.690-693.3226

Paper Titles

Abrasive-Free Polishing of Hard Disk Substrate with H₂O₂-K₂S₂O₈-NaHSO₃ Slurry
p.3209

Aspherical Surface Contact Detection Error Analysis
p.3213

Deep-Hole Precision Honing of Difficult-to-Cut Materials
p.3218

Effect of K₂S₂O₈ on Material Removal Rate in Abrasive-Free Polishing of Hard Disk Substrate
p.3222

Electrochemical Deburring of Miniature Holes
p.3226

Numerical Analysis of the Ultrasonic Honing Chatter Based on the Stribeck Model
p.3231

Quantitative Analysis of Lateral Setting Error in Two-Point Method
p.3235

Simulation Analysis of Thermodynamics on the Belt Spindle of the Machining Center
p.3240

The Effect of Geometric Error on Machining Accuracy for Machining Center
p.3244

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 690-693Electrochemical Deburring of Miniature Holes

Electrochemical Deburring of Miniature Holes

Abstract:

Electrochemical deburring (ECD) was used to remove burrs, which exist in the intersections of the miniature drilling holes and the inner wall of stainless steel pipe. Via experiments, the influences of the processing parameters on the deburring quality and the change law of the voltage between the electrode and workpiece were explored, such as process time, electrolytic composition, concentration. The ECD results showed that the burrs can be removed with good quality and efficiency in the condition of optimal selecting parameters.