Study on High-Speed Milling Force of SiCp/Al Matrix Composite

Long Xin; Jun Juan Lv

doi:10.4028/www.scientific.net/AMR.690-693.338

Paper Titles

High-Temperature Dry Sliding Friction and Wear Characteristics of As-Cast SiC_P/A356 Composite
p.318

Influence of Fiber’s Surface State on Mechanical Properties and Fiber-Matrix Interaction of CFRP
p.323

Microstructure and Properties of Deformation-Processed Cu–Cr In Situ Composites
p.329

Preparation of the High Temperature Resisting Material with Al-CrO₃ System by SHS
p.334

Study on High-Speed Milling Force of SiC_p/Al Matrix Composite
p.338

Synthesis and Characterization of MgFe₂O₄ /MgO Composite Films from Layered Double Hydroxides Precursors
p.342

Synthesis Method and its Influence Factors of Hydrotalcite-Like Compounds
p.351

The Influence of AC Perturbations on EIS Measurement of Copper/LDPE Composite with High Resistance
p.355

The Sorting Method of the same Pattern Compound Material Based on Basic Element Model of Surface Microstructure
p.359

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 690-693Study on High-Speed Milling Force of SiCp/Al...

Study on High-Speed Milling Force of SiC_p/Al Matrix Composite

Abstract:

On the condition of some milling depth and feed rate, By means of high-speed milling force measurement of SiCp/Al matrix composite, the rule for impact of milling speed on milling force is revealed successfully. In some range of milling speed, when SiCp/Al is high-speed milled, the milling force is lowered with increase of milling speed. Furthermore, the experiment also show that the optimal milling speed should be adjusted between 200 and 260 m/min for the SiCp/Al matrix composite with 56% volume fraction and particle size of 60μm.