Design of Transport Beams Arrangement in Target Area of SG-III Facility

Mei Cong Wang; Ming Zhi Zhu; Gang Chen; Wen Kai Wu; Xing Hua Que

doi:10.4028/www.scientific.net/AMR.765-767.206

Paper Titles

An Investigation of Heat Transfer Characteristic of Cross Internal Helical Microfin Gravity Heat Pipe with Self-Rewetting Fluid
p.189

An Investigation of the Operating Characteristics of Gravity Heat Pipe with Cross Internal Helical Microfin under Variable Power
p.193

Study on Normalizing Process for 100mm E40 Heavy Plate
p.197

Study on the Influence of Process Parameters on Curling Springback
p.202

Design of Transport Beams Arrangement in Target Area of SG-III Facility
p.206

Mechanical Ball Milling and Liquid Phase Sintering of Steel-Bonded Cemented Carbide Machining Crumbs
p.210

Application of LED in Marine Fishery
p.213

Study on Principle of Spacecraft Surface Charge and Discharge
p.217

The Research of Permanent Magnet Sealing Technology in Vertical Hot Galvanized Pot
p.222

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 765-767Design of Transport Beams Arrangement in Target...

Design of Transport Beams Arrangement in Target Area of SG-III Facility

Abstract:

In target area of Inertial Confinement Fusion (ICF) facility, the rectangular beams arrangement at the main amplifier (MA) output is mapped to the spherical-geometry beams configuration near the target chamber. The beams are imported into the final optical assemblies with special angles. In this paper, the transport beams arrangement design of SG-III facility is described. Firstly, the primary requirements of the transport beams arrangement in ICF target area system are given. Then the typical transport beam pathway from the MA output to the target chamber center is analyzed. The general layout, beams path length, and the parameters of transport mirrors are discussed for the transport beam arrangement.